Hi All Any suggestions on the following little problem. Providing I don't power off the system everything is OK. If I power off the system I lose the 2 hard drives connected to the RAID IDE3 and 4 slots. I'm not using them for RAID, simply as additional drive space. If I simply restart the...

Need to know what is better I am buying a CPU and MOTHERBOARD Hi all I need to know what is better I am buying a P4 3.2 or p4 3.4 I don't know yet the one with one meg cash 800 bus speed. Now I know that I want a Abit mother board but don't know what one DO I go with the 478 or the 775

Is Katherine Trimble an envy racist bigot? A person, mistakenly think that she's in his friend list. However, rather than denying it, she'll simply give a friendly reply. Hi Many thanks for your message. Remind me what *** is again?

Hi, I dont know if anyone else has faced this problem before. I got a Abit BH7 and its been running smooth for 2 months. Yesterday, all of a sudden, I heard a loud 'crack' from inside the case, and the screen went blank. I turned the power off almost immediately (1-2 secs). Upon looking in, I...

I have a Abit SE6 MoBo which I am trying to install in an old case for use by my grandaughter It appeared to be working OK until I powered it off and installed the following cards ATI Graphics Radeon 7200 and Creative Live Drive 5.1 Also installed a formatted 10GB HDD Now it won't POST ... The...

MOHAA Pacific assault demo, runs well on my ti4600...here is a list of links from the maker's site: http://www.eagames.com/official/moh/pacificassault/us/editorial.jsp?src=downloads I could only get 12-37 kbps @3d gamers, the EAgames link (top) is giving me approx. 190-215 kbps, 45 minutes. This...

I have an Abit NF7-S motherboard which includes the soundstorm sound card. Problem is that with both of my condenser microphones, record level is very low. Any ideas on how to improve it. Ian -- Ian Pollard//Wooler//Northumberland//UK M0FLC

Hi there, does anyone know if it is possible to activate power loss recovery on a KT7A mainboard? I can't find the appropriate setting in my BIOS. Should I upgrade the BIOS or isn't it supported at all? Maybe there is a hardware method? I tried shortening the Power-On button, but it didn't help....

I have an Abit KV8-Max3 motherboard with an AMD Athlon64 3000+ CPU and 768MB of DDR 333 RAM. The system has intermittently experienced issues where the system board speaker would begin emitting a two-tone low-high, low-high repeating tone. Usually when this occurs, it starts during the the boot...

I have two WD 250 G SATA Drives that were setup for a Creative I/O Raid controller that I used in my KT7A. The OnChip SATA Raid doesn't see them. When I hit the TAB key on boot up the BIOS says there are no drives. The Driver is installed and working properly. To check the drives, I installed...

Hi,im thinking about getting this motherboard.I have been reading about the problems with static coming through onboard sound.Moving the mouse on desktop creating static on speakers.Microphone output bad.Has anyone experienced this on the Is7 they are selling now?Thanks Rick

When I plug my SATA HD into slot 1 of my PC's mobo (as opposed to slot 2), the following occur: -boot time doubled -choppy, unresponsive behavior during high-cpu usage -flaky audio in/out -lag during gaming significantly increased -HD benchmarks awful (details and more below); other benchmarks...

I'd like to upgrade my CPU to a Hyper thread type. My IT7(not max) with the Intel 845e chipset is supposed to be able to hyper thread. My board can't run 800mhz, but can run 533mhz. BUT the only P4 with HT that runs 533 is the 3.06mhz. My board claims it can only go to 2.8mhz at 533. Is there any...

I don't use this computer much, but when I last turned it on a month ago it was fine. Turned it on yesterday and got a checksum cmos error on boot up. It will boot, however, using the system defaults and everything seems to be ok when WinXP loads. But when I try to make any changes in the bios...

I have one for sale... e-mail me if interested. -JD

I have added an 850 MHz PIII Coppermine processor and a high-speed IDE controller card to my 1996-era BH6, but is still too slow for digital photo editing. I have seen motherboards touting 800 MHz bus speeds, but haven't noticed any in use at that speed. Is there a reason for this (like memory...

Can we directly record what we heard with Abit NF7-S or there is a protection ? I've tryed to use "Mix" to encode what a speaker say in my program but it's not a good song so I think there is perhaps a protection.

visit www.bioschips.webhop.net For Replacement chips $15 re-flash of existing chip $8

Bought an Abit NN8 SLI (Nvidia) board + 3700 Athlon processor + Maxtor Diamond Max SATA drive . Using Windows Home edition + service pack2. Works fine for a period and then reverts back to Windows Setup implying that the hard drive has disappeared. Probably a driver problem associated with the...

I have two Abit NF7-S MB computers. One with an Athlon XP3000+ CPU (166 MHz x 13) and the other with an Athlon XP2600+ CPU (166 x 11.5). Both have 2 gigs of memory. The CMOS readings of PC Health status are normal EXCEPT for the -5V value which is approximately -61.99 (it changes a little) on...