|
|
7NNXP and Linux lm_sensors by
Andrea Magatti
Has anyone had success in using lm_sensors with this motherboard?
I'm currently using kernel-2.6.2-rc3 and lm_sensors cvs.
Seems like the controller is it87.
sensors gives me actually 3 values about the temperatu
one of this measures system temperature and gives me the same value i
get from the...
|
|
0 |
143 |
|
|
7NNXP boot problems by
Chris Luther
Hi
Anyone got one of these 7NNXP boards.. I am having problems warm booting..
It doesnt.. it takes about 3 mins to POST whereas from a cold boot it takes
max 1min. Also when warm booting the system wont.. it will POST after some
time then will check every boot device and prompt with a message that...
|
|
2 |
495 |
|
|
7NNXP Modem Woes by
Dale Frameli
Anyone have a modem installed in their GA-7NNXP? If so, which
PCI slot are you using? And, is it working reliably?
I've tried every PCI slot and have found that my USR will not pass a
modem diagnostic no matter which slot the modem is plugged into.
Currently, I have the modem plugged into PCI...
|
|
0 |
243 |
|
|
7NNXP PCI Slots:Can't run audio cards?? by
Elden J Montagne
I need some education, I think.
7NNXP has 5 PCI slots. I need to use any 2 for
high-end audio recording cards (M-audio 1010LT).
I do not need any other PCI cards.
BUT: The many onboard peripherals share these slots,
and I can't get any unshared IRQ's on even 2 PCI slots!
What am I missing? I can...
|
|
5 |
280 |
|
|
7NNXP Raid and CPU Problems, new install by
The Halls
Upgraded my MB with a new 7nnxp, the board is seeing my AMD 2100+ as an
1500+. I have tried setting fsb and cpu ratio in the bios but it does not
change the processor speeds.
Second issue is when I put a second drive on the raid controller the system
will not boot to OS. Bios sees both drives...
|
December 8th 03 05:52 AM
by jpsga
|
1 |
291 |
|
|
7NNXP Sound by
Eyghon
Hi,
I run a 7NNXP and Creative DTT2200 Speakers. Is it possible to add-in a
headset without losing any of the speakers. The MIC works fine but I can get
the headset speaker to work. I have a Logitech Dialog-811 headset, should I
have gone for a USB headset?
TIA
Eyghon
|
February 26th 05 03:36 PM
by Eyghon
|
4 |
170 |
|
|
7nnxp sound problem by
Stephen Sherman
I have had this 7nnxp for a few months now and have had a problem with the
onboard sound. The right channel comes out with static over it. I have
tried driver updates, bios updates, different speakers but to no avail.
Does anyone know how to fix this problem?
Stephen Sherman
|
September 6th 04 01:13 PM
by jpsga
|
1 |
244 |
|
|
7NNXP temperature sensors by
vagabond
Hi
My PC speaker makes the occasional random beep, so I thought to look at
temperatures using SiSandra (just in case but I guess something else is
causing the beeps).
SiSandra reports:
Board Temperature 36°C
CPU Temperature 28°C
|
|
0 |
775 |
|
|
7NNXP....... by
Eyghon
Hi,
I've just replaced mobo with a 7NNXP and Seagate ST3120026AS SATA drive.
I've been trying to get WinXP to install but if I copy the drivers to floppy
from either the Gigabyte CD or Website I get the following error after
pressing F6 when it reads the floppy:
txtsetup.oem caused unexpected...
|
October 5th 03 03:15 AM
by jswing
|
1 |
132 |
|
|
7NNXP/Sata - Waiting for Explorer to display by
Pudn
There may be something I've missed somewhere. My system appears to work ok:
boots up very quickly, applications appear to be ok too I built this
machine about a month ago and its now starting to annoy me!
My problem is that when using Windows Explorer and browsing around it takes
a long long...
|
February 5th 04 09:40 AM
by Pudn
|
3 |
217 |
|
|
7nnxvp on board igp by
anti
Hi all
Has anyone with this board had any problems with the onboard vga???
when i try to run any 3d apps the screen is full of lines and artifacs,
until it locks up.
ive tried lots of different drivers, fresh installs of xp with each driver
i have an enermax 465watt psu so i dont think its that,
my...
|
January 25th 04 07:20 PM
by anti
|
0 |
175 |
|
|
7VAX BIOS v10 by
WolfSKill
Updated my BIOS from v4 to v10 today becasue i went from a 2200XP to a
3000XP barton and needed the 10 BIOS for the barton support. Everything
works well, but one thing i am noticing is that my maxtor 160 gig 133 ATA
drive is now showing up at post as PIO 4, and i have it set to 66/100/133
and...
|
|
0 |
165 |
|
|
7VAX BIOS v10 by
WolfSKill
Updated my BIOS from v4 to v10 today becasue i went from a 2200XP to a
3000XP barton and needed the 10 BIOS for the barton support. Everything
works well, but one thing i am noticing is that my maxtor 160 gig 133 ATA
drive is now showing up at post as PIO 4, and i have it set to 66/100/133
and...
|
|
0 |
134 |
|
|
7vaxp and sempron by
Tim
Anyone tried one of the new Sempron processors on the 7vaxp? Giga-byte
shows they are testing the 3000+ chip. Anyone running the 3100+ chip?
Any problems noticed?
--
/s/ Timothy I. McCrory
"Tyranny has no enemy so formidable as the pen."
William Cobbett
|
February 1st 05 01:00 AM
by Tim
|
0 |
156 |
|
|
7vaxp bios setting? by
NeoZ
what's the best bios setting for my 7VAXP if I use it for Home
theater(whatching dvd movie)?
Movie were always scratchin' 'till I disable Smart function and voilą! now
movies are very good but not at the best,there are still some problem.
My sistem is
7vaxp(bios f14 and latest via driver)
athlon...
|
December 23rd 03 01:55 PM
by NeoZ
|
0 |
243 |
|
|
7vaxp ultra + Sata Seagate 120gb (hard disk dated 7/11/2003) by
Dimitris
Has anyone make the above compo to work using the onboard silicon
image controller?. The bios of the onboard controller is rather
old(4.1.35c) while the newest available is 4.2.15. I hope gigabyte
delivers a new bios soon cause bios flashing(using silicon image
utilities) works only for pci sata...
|
|
0 |
419 |
|
|
7vaxp ultra and sata seagate 120gb by
Dimitris
Guys who have made these two to work with the onboard
controller(sil3112) please let me know what you did and your computer
configuration/synthesis.
The seagate drive is ST3120026AS and its date 7/11/2003. It works
perfectly with a PCI sil3112 controller but has problems in reading
data with the...
|
|
5 |
499 |
|
|
7VAXP Ultra digital output question by
Heckler ²°°³
Hi all
Got a quick question about outputting through the spdif socket into my 5.1
amp. I've got it all hooked up, but I can't get any sound from the rear
speakers unless I'm playing a dedicated 5.1 source through say Power DVD.
Also I can't get any sound when I use my TV card (Hauppauge WinTV...
|
|
0 |
497 |
|
|
7vaxp ultra f4 v 1.2 cpu temp by
J
A client's machine
7vaxp ultra f4 v 1.2, 2600+ with stock AMD HSF.
The bios pc-health page reports 49 degrees for system temp and 49 degrees
for the CPU.
The case is open, the power supply is out.
I suspect this is not a correct reading.
|
August 27th 04 11:39 PM
by J
|
0 |
375 |
|
|
7VAXP Ultra running a 3200+ at 400? by
John Smith
Just curious, If I install overclocked memory @466. Can I run an XP 3200+ @
400?
I guess it's wishful thinking, don't think my 5200 FX ultra video card could
handle it.
|
|
0 |
783 |