A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Board temerature by DavidM
Hi Builder, My board version is 2.1. Just an after thought as you are running the same board my motherboard TEMP is around 33 c with nothing running. Anyone know the optimum temp for the CPU/Board. Thanks
September 16th 04 06:29 PM
by DavidM Go to last post
1 186
GA-81K1100 - approved list of RAM? by Schnaut
Hi! A friend of mine (so far anyway, as it was me that recommended the mobo in question) has severe problems with the GA-81K1100. It restarts every 5-10 minutes, disregarding what application being used. Tried many things, with no luck so far. I understand that the RAM can be a problem, and we...
September 16th 04 07:47 PM
by Schnaut Go to last post
0 352
BIOS CHIPS : New Replacement Bios Chips $15 or Re - Flash $8 by iCE Flashing, INC
BAD BIOS CHIP FLASH? VISIT: http://bioschips.nlan.org For Replacement chips $15 re-flash of existing chip $8
September 17th 04 12:21 AM
by iCE Flashing, INC Go to last post
0 303
Setting Award Bios User password by Jeff
Hi, I have two gigabyte MB's Ga8IRXP and GAIEXP with award bios .On other non gigabyte MB's with therir bios I was able to state a user password that would prevent the sytstem from booting at all unless you entered the password. Here instead I seem to be able only to protect access to the bios...
September 17th 04 01:35 AM
by Jeff Go to last post
2 509
RMAing a fried Gigabyte Video card in Australia, possible ? by Little TeaPot
My nephew had his 9600 pro vid card fry, i know he was not overclokcing it, prob does not even know how :) What sort of warranty does the card have itsonly somthing like 6 months old, what sort of change do i have to get it replaced ? Do they test it ? Thanks.
September 17th 04 04:19 AM
by Little TeaPot Go to last post
4 422
GA-8KNXP CPU support sheet by Richard Dower
It's been updated, supports everything now: http://www.giga-byte.com/Motherboard/Support/CPUSupportList/CPUSupportList_GA-8KNXP%20(Rev%202.0).htm
September 18th 04 12:13 AM
by Richard Dower Go to last post
0 261
TH7-II RAID replacement? by Pheasant Plucker®
My TH7-II RAID has served me well being quick & robust over the last 3 years and has coped with everything I have ever thrown at it - (the same applied to my previous mobo, the Asus P2B-LS which also had a 3 year life-cycle). I am however looking for a replacement for the TH7 because I am being...
September 18th 04 05:03 AM
by NuTCrAcKeR Go to last post
1 400
66MHz PCI on GA-6BXDx? by Spam Averse
I have both 6BXDS and 6BXDU motherboards, each of which has an elongated PCI slot adjacent to the AGP slot. The description of each board lists only the 4 33MHz PCI slots. In the graphic depiction of the boards all the PCI slots look the same. However, there is a tantalizing hint. The sparse...
September 18th 04 05:16 PM
by Spam Averse Go to last post
2 382
GA-8IHXP 850 Chipset and HT Tech???? by Builder
I have had the above motherboard for the last year or so and I must say its the best board I have ever owned. I have certainly kept it the longest without upgrading. I am purchasing a 3.06 pent 4 533 MHz HT CPU. I have upgraded to latest Bios which is said to support HT Technology. I don't have the...
September 18th 04 10:34 PM
by Builder Go to last post
4 246
will new 400Mhz FSB mobo work with old 133Mhz FSB AMD processor? by Tone-EQ
Hi all, I have an old system with: VIA KT133 Motherboard AMD Athlon XP 1600+ Processor 256MB 133Mhz SDRAM now, my motherboard died so I have to buy a new one. I want it based on VIA KT400 chipset, can I leave my old 1600+ Athlon, and use it with the new mobo? I really...
September 19th 04 09:00 PM
by Michael Stum Go to last post
4 499
GA-6VXC7-4X problem with WINDOWS XP by bruno
I have problems with my AGP card, a ATI RAGE 128, in windows XP adn windows 2000: 1) The system becames instable (hangs randomly, the screen freezes, maybe audio keeps on for a while, then it reboots). After reboot windows XP shows a message like this: A problem occurred with the video adapter...
September 20th 04 11:37 AM
by bruno Go to last post
0 487
Dual Display on 8i845Gvm-rz by Bill G
The 8i845gvm-rz uses the Intel 82845G graphics controller and does support dual display, yet when I add a graphics card the PC will stop booting at the white "Windows 2000 setup screen". The board only has PCI slots. I am using a graphics card that was working with dual display in another...
September 20th 04 10:25 PM
by David Wang Go to last post
1 892
Memory Recommendation for K8NS Pro by JR
My previous board was a K8N Pro and I had Corsair TWINX 1024-3200LLPT and it worked like a charm but it topped out @ around 235FSB. Recently I purchased a Gig(TWINX) of the XMS4400 with the spec 3-4-4-8, my question is will this necessarily work as well or better? Recently I've used it on 2 other...
September 21st 04 03:36 AM
by JR Go to last post
0 222
Strange Problem by Builder
Using an GA-8IXP. The case fan has a speed control (variable resistor) on the front of my case. The case fan gets it voltage from the MB sys fan pin outs. When I turn up the speed of the fan the computer shuts down. When I disconnect the speed control for the fan all is well but fan runs at...
September 21st 04 11:30 PM
by Tim Go to last post
2 322
Internal I/O Connectors Gigabyte 7VM400M-RZ by Gonzo
I noticed that my 7VM400M-RZ mainboard has some internal IO connectors for extra USB 2 connectors and a joystick / MIDI plug. Where can I purchase these connectors? I see nothing on Gigabyte's web page for them. Anybody ever purchase any of these?
September 22nd 04 04:49 AM
by Gonzo Go to last post
0 384
Flashing Bios Problem with the GA-K8VNXP by Lawless
I downloaded a bios and updated it using the windows flash utility. When I started the computer the power and HDD leds were on. The system doesn't post anymore........any one got any suggestions.......(And if the answer is it is stuffed.....I figured it is) Funny thing It shouldn't do it in...
September 22nd 04 05:06 AM
by Lawless Go to last post
0 260
GA-7N400E-L by Nitro®
I just installed a second stick of 512mb pc3200 ddr cl3 ram ( new stick-micron, original- nanya ). upon booting the machine the memory test was OK and XP started to boot. As it arrived at the desktop the machine rebooted, this happened on every subsequent attempt. I tried safe mode etc. all with...
September 22nd 04 10:05 AM
by Rick Go to last post
1 373
Motherboard monitor and GA-8I915G Pro by C.u.b.i.k
Anyone got Motherboard monitor to work correctly with this mobo? I know Gigabyte supply some software which does basic monitoring but to be honest, it's a bit rubbish. Failing that, are there any alternative pieces of software which will monitor things? I'm thinking of getting a quieter fan and...
September 22nd 04 11:24 PM
by krzysiek Go to last post
1 377
New 8KNXP Rev 1 bios F12 out by Tim
Its been there 3 days now..... says "Fixed 0F41 CPU can't boot issue". No mention of ITE RAID bios. http://www.giga-byte.com/Motherboard/Support/BIOS/BIOS_GA-8KNXP.htm - Tim
September 23rd 04 06:14 AM
by Tim Go to last post
0 487
GA-8KNXP 2.0 - FJ BIOS by Richard Dower
http://www.giga-byte.com/Motherboard/Support/BIOS/BIOS_GA-8KNXP%20(Rev%202.0).htm Download here, dated September 15th 2004: http://www.giga-byte.com/Download/Download.asp?DownloadPath=/MotherBoard/FileList/BIOS/bios_8knxp2_fj.exe Not tried them, i just HOPE they fixed the boot delay issue i...
(Multi-page thread 1 2 3 ... Last Page)
September 23rd 04 03:25 PM
by Brendan S (Scratch User) Go to last post
37 1,579
Post New Thread


Display Options
Showing threads 1881 to 1900 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 10:08 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.