|
|
GA-7N400 Pro2 Raid Problem by
TonyF
Upgraded to GA-7N4000 Pro2 . XP repair installation worked OK and boots to
XP Home OK with RAID option in BIOS disabled.
BIOS sees 80 Gig HD (ATA 100) on IDE 0, DVD Drive and DVD rewriter on IDE 1.
But if I enable RAID HW in BIOS it runs scan but no IDE drives detected on
IDE 1 to 4 ! Thus RAID...
|
August 7th 04 12:26 AM
by henny
|
4 |
389 |
|
|
GA7n400-pro HyperX RAM SLOW by
Hervey Cleckley
I had 2x256 HyperX (CAS2.5 @ 200mhz) and my memory benchmarks were great.
I added another 2x256 HyperX and I couldnt even get the system to boot until
setting all BIOS memory settings to most conservative timings.
Now i benchmark slower than PC2700.
What the dilly-yo?
|
August 6th 04 11:20 PM
by jpsga
|
1 |
158 |
|
|
GA-7N400 Pro2 r1.1 & Corsair TwinX512-3200XLPT by
Tim
Greetings,
Is there a way to get this memory to run at 2-2-2-5 (advertised speed)
on this board and a way to check that ? When I try the turbo memory
speed setting in bios, it locks up tight, and CMOS reset is required
to restart. The PC is very stable, otherwise.
F6 bios
No overclocking, good...
|
August 6th 04 10:24 PM
by Tim
|
3 |
169 |
|
|
running DDR40 at 333 GA7N400 Pro by
imnotawomble
Hello everyone.
Just got myself 2x512mb DDR400 even though my processor runs at333. My
problem is that when using these my system is highly unstable. I would
imagine that it would just underclock to run at 333.
Does anyone have any suggestions or should I assume that at least one of
them is...
|
|
2 |
174 |
|
|
GA 7N400 Pro2 - Northbridge fan by
Mark Epps
I've seen a couple of posts relating to replacements for other m/b's, but do
you guys have any suggestions for a
replacement of my northbridge fan?
the standard one makes all sorts of odd grinding noises, and sounds really
ropey.
cheers
mark
|
August 6th 04 05:27 PM
by Si
|
1 |
301 |
|
|
|
|
0 |
317 |
|
|
New GA-8KNXP drivers by
Richard Dower
Intel Application Accelerator 4.5
http://downloadfinder.intel.com/scripts-df/filter_results.asp?strOSs=44&strTypes=DRV%2CUTL&ProductID=1809&OSFullName=Windows*+XP+Professional&submit=Go%21
Intel® 82547EI Gigabit Ethernet...
|
August 5th 04 11:45 PM
by M-Tech
|
1 |
355 |
|
|
SATA crashing system by
no spam
Hello,
I have a machine based on a Gigabyte GA-7VT600 1394 mother board. I am
running Win XP Pro SP1. My current hard drive configuration is as C: boot
drive, one 18gig SCSI drive (connected to an LSI SCSI card), one IDE 160gig
Seagate (8mg cache) on the Primary IDE channel, and one SATA 80gig...
|
|
0 |
457 |
|
|
SIS 7001 USB 2.0 - DISAPPOINTTED by
Wesley
I'm build PC SiS GA- S648 FX and revealed they all running USB 1.1 nooone
one for USB 2.0 in the Windows XP and I'm told need to get PCI card that
solved it. I'm told there patch usbdetact.exe and stilll nothing change.
Very disappointing... and told SiS is working for the patch for USB...
|
August 5th 04 09:52 AM
by Wesley
|
0 |
202 |
|
|
CPU FAN by
Deely Hunter
MB is GA8KNXP.
For some reason my CPU fan goes into noisy 'hyperdrive' even a low
temperatures.
Is there someway I can tell it wait till a certain temp before cranking up
the speed.
|
|
1 |
177 |
|
|
|
August 5th 04 05:42 AM
by gk
|
0 |
142 |
|
|
New GA-7N400 Pro2 and old drive don't work together... by
FredEX
Just up graded from a GA-7VRXP to a GA-7N400 Pro2 because my new
XP2800 (333) processor wouldn't go above 2000 in the older board.
(266fsb limit)
I was hoping to use Windows XP that's on my 120 gig drive that I used
with the 7vrxp board. As per my usual luck, it won't boot.
I've tried changing...
|
|
5 |
340 |
|
|
GA-8KNXP 2.1 page update by
Richard Dower
http://www.giga-byte.com/Motherboard/Support/Driver/Driver_GA-8KNXP%20(Rev%202.0).htm
|
August 4th 04 01:38 AM
by M-Tech
|
6 |
193 |
|
|
GA-K8NSNXP-939 - Anyone? by
Golgatha
I am looking at right now, just got it today..
I have not started building yet, will let you know how it turns out..
Wish me luck!
"fyrfaktry" wrote in message
...
I am looking at this MB very closely. Potential setup-
AMD...
|
|
3 |
296 |
|
|
GA-6VXC7-4X Beep Codes by
James Purser
Can anyone point me to the Beep Codes for the GA-6VXC7-4X board? I
downloaded the manual and I can´t find them anywhere.
James
|
|
0 |
265 |
|
|
how to enable P.A.T. by
JohnC
How is P.A.T. enabled , ga-8ik1100rev2
Is it the optimized default settings in the bios ? if so, is this better
than raising the fsb......i'm runing a 2.8 @ 3.0 now using
fsb.............thanks......JohnC
|
August 2nd 04 09:30 PM
by Zac
|
1 |
120 |
|
|
GA-7N400 Pro2 - With Athlon 3200XP by
Mr_K
I have tried (I think) all combinations to get this processor to appear at
boot up at the correct frequency.
The system keeps saying Athlon 1100.
I have set everything to auto, I've set the bus to 200 in the bios, I've
tried manual settings, but I'm stuffed!!!!
Can anyone give me an idea where I...
|
|
5 |
156 |
|
|
Problem With 'All SATA Setup' with GA-8KNXP Ultra-64 by
Jeff French
I've built a new computer around the GA-8KNXP Ultra-64. I have an ASUS
DVD-E616P1 with an ACard AEC-7900A SATA-to-IDE Converter, a Plextor PX-712SA
(SATA) DVDRW, and three Western Digital SATA hard drives (2 WD740GD Raptors
and 1 WD2500JD).
As you can see they are all SATA devices. One would think...
|
|
2 |
363 |
|
|
The MOST basic setting for a GA7VAXP by
The Dude
hi, is it possible for any of you guys to give me a non-overclocked
(default) motherboard setting for my following system:
athlon xp 2200+
ga7vaxp (BIOS ver F14) mobo
wd 80gig 7200 8mb
2 sticks of Kingston Valueram 512mb DDR400 each.
gigabyte ati radeon 9600xt @ 8x agp
thanks guys.
|
August 2nd 04 04:49 AM
by jpsga
|
2 |
167 |
|
|
Audigy problems with K8VT800 by
Paul Mc
Hi,
I've recently built myself a new system based around the Gigabyte
K8VT800 motherboard, with an athlon 64 3000+ cpu and 512 400mhz DDR.
Everything on this system works as per expected apart from one thing..
the old audigy sound card I have, as soon as I plug this into the
board - I get no...
|
|
0 |
532 |