A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » System Manufacturers & Vendors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Compaq Servers Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Power supply signal cable header for COMPAQ Proliant DL 380 by Mike B.[_2_]
Hi. I'm trying to substitute the COMPAQ DL380 (G1) Server Mainboard with my VAX 4000 KA54, NVAX 100MHz Mainboard to get rid of the BA42A Case. The mechanical rebuilding is simple. The SCSI devices (4x36GB,Plextor-CDROM und 12/24GB DAT) are identified and operational. Floppy and IDE-CDROM are...
March 23rd 08 05:53 AM
by Phil Go to last post
3 920
ML 370 Gen 1 Problem by Kevin
My Proliant ML 370 Gen 1 has crashed and given me the error 101 ROM IO Error when I reboot. Where do I look for the problem? It has a Compaq 431 RAID controller with 5x9.1 drives.in a RAID 5 configuration. I have green lights on the drives. I do have the onboard chip I can use to replace the 431...
March 2nd 08 06:23 PM
by Kevin Go to last post
0 686
RAM installed discovery? by just bob[_2_]
I need to add RAM to a server - is there a way to see which slots are used? We have a few old DL380's G3 a few DL320's G4, and one very recent ML350. Thanks!
March 1st 08 01:10 AM
by just bob[_2_] Go to last post
0 490
ML370G2 not supported? by dougf
Hi Folks, Been a while since I've posted anything here, I have an interesting problem and was hoping there is a work around. I'm trying to use a 641 Array controller on a ML370G2, but found when I insert the card I get a type 2 header error, and the BIOS will not recognize it. HP support matrix...
February 29th 08 07:54 AM
by Jez T Go to last post
1 473
P600 Inverts Logical Devices by Will
On a P600 controller, after rebooting it has inverted all of the logical device numbers! Drives were ID=0 ID=1 and ID=2. The 0 drive is now 2. The 2 drive is now 0. How is this even possible? How can you recover back the original drive order? -- Will
February 14th 08 06:15 AM
by Will Go to last post
0 552
DL385 With Two P600 Adapters by Will
Does anyone know if the DL385 is allowed to run Windows 2003 32-bit with TWO P600 adapters? We have one of these with cabling to the internal SAS 2.5 array in a DL385 and the second one has its external port attached to an external MSA50 2.5 SAS array. We mirrored the boot device across the...
February 14th 08 03:08 AM
by Will Go to last post
0 907
PS Pinout, HP/Compaq Proliant DL320S? by [email protected]
Does anyone happen to have the pinout (really, more of an edge- connector-out) for the power supply for the Proliant DL320S rack mount system. The power supplies are 575W, hot swappable units which output 47A @ 12V and 5A @ 5V. The connector is an edge-connector type on the inside- end of the...
February 2nd 08 12:39 AM
by [email protected] Go to last post
3 1,323
Power Supply Filler for MSA 50? by Will
Does anyone happen to know if there is a power supply blank slot filler for the MSA 50? Power supply for that system is 377230-001. -- Will
January 28th 08 04:03 AM
by Will Go to last post
0 592
Compaq Presario 5834 Restore Disk files needed! by [email protected]
I need some of the files on the restore disks for the 5834, my disks are scratched, does anyone know how I might be able to get them? Compaq no longer has them or provides support for older models but I'm trying to restore it for my daughter.These are the ones I need: FILES MISSING DISK ONE In...
January 10th 08 03:47 AM
by Phil[_9_] Go to last post
5 668
Anyone have a DL360 G2 to sell real cheap? by msg
Greetings: I would like to find a DL360 G2 (or newer) cheap with reasonable shipping costs (unlike on eBay); it need not have an HD or much RAM but should have a CPU (and embedded 1000BaseT). A working mainboard would be another option (with proprietary cables if you have 'em). Regards,
January 3rd 08 06:24 PM
by Rick F Go to last post
5 717
Nut Cracker You OK? by Phil[_9_]
LG, Not heard much from you lately, all ok ? Phil
January 2nd 08 09:17 AM
by msg Go to last post
1 458
Problem with a DL380 by [email protected]
Hello I have a DL380 933mhz 512megs, right now no hard drives. A little history first. I had this server in storage for a while. I was going to put Linux on the system, but decide against it. When I took the server out of storage at first the server would not power on at all. The power light would...
December 13th 07 10:40 AM
by [email protected] Go to last post
0 510
ML330E system board by wireman via HWKB.com
I've picked up a used ML330E system board (230540-001) which seems to have been common in qute a few Compaq server models. It has a 933Mhz CPU (or thereabouts) and various PCI's including features board, network card etc. My intention is to use it in a standard ATX tower as a server on my...
December 3rd 07 01:01 PM
by Phil[_9_] Go to last post
1 593
Getting a DL380 G1 image by [email protected]
I currently have a DL380 G1 that is running netware 5.1 and GroupWise 7.0.2 We are migrating the GroupWise System to a G4 running Linux but I first need to obtain a good solid image (not a file by file copy) of the data in case of a meltdown so that I can lay the image back down and be back up and...
November 19th 07 10:23 PM
by msg Go to last post
1 507
Can DL380 G4 Convert to SAS? by Will
Is there any conversion kit that will convert a DL380 G4 from SCSI to SAS? -- Will
November 8th 07 04:33 PM
by Benjamin Gawert Go to last post
5 780
Any reason to NOT get a use Proliant DL580? by Rick F
Someone locally is selling a used DL580 for $80.. It's populated w/ 2Gb of RAM, and two 900Mhz Xeon processors.. The only thing I don't know about yet is what generation machine it is.. Anyway, assuming there are no huge differences between generations, is there anything special I should know...
November 2nd 07 07:41 AM
by Rick F Go to last post
5 507
Problem installing NT 4 Server on DL380 G2 by [email protected]
I am getting a bluescreen installing NT 4 server on a Compaq Proliant DL380 G2. The bluescreen message is "NO SYSTEM PTES". I installed the SCSI 5300 driver also. Any ideas? Thanks.
(Multi-page thread 1 2)
October 31st 07 08:55 PM
by Benjamin Gawert Go to last post
11 1,031
Fatloss computer program by Angel vasquez
I have been using this computer program for a couple weeks now and i am very pleased with the results so far. its a software fatloss program, if your looking for a diet/weightloss plan i reccomend you check this place out first: http://fatloss9.50webs.com
October 16th 07 02:16 AM
by Angel vasquez Go to last post
0 542
Configuring ILO remotely? by Bob Mgr
I just was talking with someone who said my most recent server, a ML350 G5 could be booted into BIOS and modified remotely via ILO. I admit I have no idea how this works so I'd like to explore more. We got someone at the remote site to plug a cable into the ILO port but beyond that I have no...
October 14th 07 12:36 PM
by Jez T Go to last post
1 505
Watch NFL Games Online by Dexter H.
Watch NFL Games Online! For every one who wants to watch the games online because they dont live in the teams town or are at work i found a site that has basically every game covered. Its perfect if you have afford a monthly $70 direct tv nfl access subscription. they got a bunch of channels The...
October 14th 07 04:31 AM
by Dexter H. Go to last post
0 618
Post New Thread


Display Options
Showing threads 21 to 40 of 853
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:30 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2004-2022 HardwareBanter.
The comments are property of their posters.