I Have a Abit KD7A motherboard with a Barton 2500+ CPU. All the L3 cpu straps are intact and uncut so the CPU is unlocked. However I can't change the multiplier. When I use the softmenu and user configuration it says it changed it but it doesn't. The boot up remains locked at 11x multiplier. When I...

I am currently using a KX7-333R mobo and I have 3 sticks of PC2700 512MB memory. I have followed the direction for loading the memory into the DIMM slots (ABIT goes 4 to 1) and everything seemed to work great. then I started getting a blue screen doing a memory stack dump. I then removed...

visit www.bioschips.webhop.net For Replacement chips $15 re-flash of existing chip $8

Why ? Gandalf Glimlach - be wary of OZC however Richard Rollins wrote:

Just ordered this board to use with watercooling. Same Hardware features as IS7, but has 3.2vdimm and all the new uguru, blackbox etc. features. cheers

Will it handle a XP2400+?

I have a VP6 with 1 leaking 1500uF 6.3V cap & a bunch of bulging caps of the same kind. They're all Jackcon. I'd like to know if someone knows of a company/someone that replaces caps in the EU. I'm in Portugal. Its really a shame to throw this board in the trash for a problem i could probably fix...

I've got TWO NF7-S systems and they BOTH hesitate for a second or two at a time at a rate of maybe two or three per minute. Changed power supplies, memory, even the motherboard to a GigaByte GA-7N400 Pro2 and the problem persists. What could possibly be wrong? I've tried the internal sound and...

I have TWO NF7-S systems and they both hesitate repeatedly when any sound card is present. No sound card, no hesitation. It hesitates whether or not I overclock my 2500+. What BIOS settings should I adjust to stop the freezes?? Thanks!

I have upgrade my bios of my nf7s rev 2 with 1.9 but the system can't boot nothing appear on screen,NOTHING.... I can"'t do anything I AM BLOCKED..... WHAT SHOULD I DO, PLEASE........... i read on manual that after i had to clear CCMOS with jumper during few muinutes but nothing change, no...

Hello -- Does anyone know why the VP6 is limited to 2GB of RAM, when the Pentium III can address 4GB? Thanks, Route User -- ABit VP6

I've just installed a Zalman 7000A heatsink/fan to try to quiet down my system. Unfortunately when I plug everything back in and power up, the system only gets power for a few seconds then everything turns off. During those few seconds all the fans spin up, so everything is plugged in properly, the...

I have TWO NF7-S systems and they both hesitate repeatedly when any sound card is present. No sound card, no hesitation. It hesitates whether or not I overclock my 2500+. What BIOS settings should I adjust to stop the freezes?? Thanks!

visit www.bioschips.webhop.net For Replacement chips $15 re-flash of existing chip $8

After about 2-3 hours of sitting idle, when I return to my system and attempt to load something new it will "hang" for 1-2 minutes before it loads the program (IE, explorer, outlook, etc). It will continue to do this until I reboot the system. It also becomes unstable, so even if you were patient...

Hi, Got a KV8-Max3 a couple of days ago and am having a few problems. Firstly, my KingMax PC3500 ram doesnt work at even DDR400 speeds in it. I put in my old TwinMos 3200 and its fine. Then I noticed it was shipped with the .14 bios, while Abits website indicates that *.15* is the latest. Ive...

Does anyone know if the new AMD Duron 1.6 GHz with FSB266 works on mobo Abit KT7 (chipset VIA KT133) ? Thanks David

Hi! I have a quick question regarding BIOS flashing on an Abit KT7A board. If this is in a FAQ somewhere, kindly point me in the right direction, but I could not find anything regarding the question on the web/googlegroups. Here goes: Abit suggests booting from a DOS floppy disk and executing...

Hi, I have just put together a system, KV7, amd athlon xp 2000. My C drive is 2 80 gig WD hard drives with serielle attachemnts in the Serial ata raid 0 configuration. I have fresh installed windows ME twice now, and both times during the installation the system shuts down and then restarts...

I bought a Sound Blaster Live! Value card (CT4780) on Ebay recently and haven't been able to get it to work. It was a bare card with no drivers. Oddly enough, I only get sound out of it when I play an audio CD. No sound from wav, mp3, or midi files. I've checked the standard culprits: sources...