Upgraded to GA-7N4000 Pro2 . XP repair installation worked OK and boots to XP Home OK with RAID option in BIOS disabled. BIOS sees 80 Gig HD (ATA 100) on IDE 0, DVD Drive and DVD rewriter on IDE 1. But if I enable RAID HW in BIOS it runs scan but no IDE drives detected on IDE 1 to 4 ! Thus RAID...

I had 2x256 HyperX (CAS2.5 @ 200mhz) and my memory benchmarks were great. I added another 2x256 HyperX and I couldnt even get the system to boot until setting all BIOS memory settings to most conservative timings. Now i benchmark slower than PC2700. What the dilly-yo?

Greetings, Is there a way to get this memory to run at 2-2-2-5 (advertised speed) on this board and a way to check that ? When I try the turbo memory speed setting in bios, it locks up tight, and CMOS reset is required to restart. The PC is very stable, otherwise. F6 bios No overclocking, good...

Hello everyone. Just got myself 2x512mb DDR400 even though my processor runs at333. My problem is that when using these my system is highly unstable. I would imagine that it would just underclock to run at 333. Does anyone have any suggestions or should I assume that at least one of them is...

I've seen a couple of posts relating to replacements for other m/b's, but do you guys have any suggestions for a replacement of my northbridge fan? the standard one makes all sorts of odd grinding noises, and sounds really ropey. cheers mark

BAD BIOS CHIP FLASH? VISIT: http://bioschips.nlan.org For Replacement chips $15 re-flash of existing chip $8

Intel Application Accelerator 4.5 http://downloadfinder.intel.com/scripts-df/filter_results.asp?strOSs=44&strTypes=DRV%2CUTL&ProductID=1809&OSFullName=Windows*+XP+Professional&submit=Go%21 Intel® 82547EI Gigabit Ethernet...

Hello, I have a machine based on a Gigabyte GA-7VT600 1394 mother board. I am running Win XP Pro SP1. My current hard drive configuration is as C: boot drive, one 18gig SCSI drive (connected to an LSI SCSI card), one IDE 160gig Seagate (8mg cache) on the Primary IDE channel, and one SATA 80gig...

I'm build PC SiS GA- S648 FX and revealed they all running USB 1.1 nooone one for USB 2.0 in the Windows XP and I'm told need to get PCI card that solved it. I'm told there patch usbdetact.exe and stilll nothing change. Very disappointing... and told SiS is working for the patch for USB...

MB is GA8KNXP. For some reason my CPU fan goes into noisy 'hyperdrive' even a low temperatures. Is there someway I can tell it wait till a certain temp before cranking up the speed.

can i use a 900 mhz duron cpu w/200mhz fsb?thanks for your help.gk

Just up graded from a GA-7VRXP to a GA-7N400 Pro2 because my new XP2800 (333) processor wouldn't go above 2000 in the older board. (266fsb limit) I was hoping to use Windows XP that's on my 120 gig drive that I used with the 7vrxp board. As per my usual luck, it won't boot. I've tried changing...

http://www.giga-byte.com/Motherboard/Support/Driver/Driver_GA-8KNXP%20(Rev%202.0).htm

I am looking at right now, just got it today.. I have not started building yet, will let you know how it turns out.. Wish me luck! "fyrfaktry" wrote in message ... I am looking at this MB very closely. Potential setup- AMD...

Can anyone point me to the Beep Codes for the GA-6VXC7-4X board? I downloaded the manual and I can´t find them anywhere. James

How is P.A.T. enabled , ga-8ik1100rev2 Is it the optimized default settings in the bios ? if so, is this better than raising the fsb......i'm runing a 2.8 @ 3.0 now using fsb.............thanks......JohnC

I have tried (I think) all combinations to get this processor to appear at boot up at the correct frequency. The system keeps saying Athlon 1100. I have set everything to auto, I've set the bus to 200 in the bios, I've tried manual settings, but I'm stuffed!!!! Can anyone give me an idea where I...

I've built a new computer around the GA-8KNXP Ultra-64. I have an ASUS DVD-E616P1 with an ACard AEC-7900A SATA-to-IDE Converter, a Plextor PX-712SA (SATA) DVDRW, and three Western Digital SATA hard drives (2 WD740GD Raptors and 1 WD2500JD). As you can see they are all SATA devices. One would think...

hi, is it possible for any of you guys to give me a non-overclocked (default) motherboard setting for my following system: athlon xp 2200+ ga7vaxp (BIOS ver F14) mobo wd 80gig 7200 8mb 2 sticks of Kingston Valueram 512mb DDR400 each. gigabyte ati radeon 9600xt @ 8x agp thanks guys.

Hi, I've recently built myself a new system based around the Gigabyte K8VT800 motherboard, with an athlon 64 3000+ cpu and 512 400mhz DDR. Everything on this system works as per expected apart from one thing.. the old audigy sound card I have, as soon as I plug this into the board - I get no...