http://www.realtek.com.tw/downloads/dlac97-2.aspx?lineid=5&famid=12&series=8&Software=True Yet another update for the realtek ALC 850 codec, the HD Audio codec drivers have also been updated for all you Intel 925X/XE...

I have just set up a K8NSNXP-939 with 2 512mb corsair ddr400 memory sticks. If I put the memory in slots 1 & 2 or slots 3 & 4, the PC wont boot, just gives regular long beeps during the post. If I put the memory in slots q nd 3, it boots up fine, but says memory not optimised because its not...

I just bought 2 200 GB Sata maxtor drives that I wanted to install on the si Sata raid controller. I installed the drives and enabled the conrtoller and during post it tells me "no devices connected" when I try to enter the raid manager. I switched it to Base to see if it could see the drives then...

hi all just got a machine in that only works with usb k/board at first i thought that there would be a setting in bios to enable ps2 or an auto keyboard setting.... looked for a keyboard setup and none could be found.....gigabyte 7s748 with an athlon 2600 / winxp i have setup a lot of 7s748's and...

Has anyone out there had any problems with loading the usb drivers for this board? Can't seem to get the damn thing to work!!! J T

Thoughts/opinions -- After updating the primary BIOS and confirming everything works, should I update both BIOSes, or leave the backup. -- Ah, the miracle mile, where value wears a neon sombrero and there's not a single church or library to offend the eye.

Hi ;) I would like to know if someone managed to install this main bord (under bios v.FJ) with this scsi extension card. ==================== PROBLEM : ==================== the scsi bios message is not shown at the boot CTRL-A is not working

I have a Gigabyte GA-8IPE1000 Pro motherboard with the F11 BIOS. Prior to now, there have been no problems in the 14 or so months that I've owned this motherboard. I can't say if it's the source of my problem, but maybe it is. I have my mouse, keyboard and two game controllers hooked up into a...

How exactly do you remove the black CPU surround/mount & backplate on Gigabyte s754 boards in order to fit Zalman CPU heatsinks? Is there a technique?

I've just built a system from spare parts: - Gigabyte GA-8IDML http://tinyurl.com/4se3t - Intel Pentium IV 1.5GHz 400FSB - 2x Kingston 256MB PC133 KVR133X64C3/256 - Gainward GeForce4 Ti4400 128MB - Western Digital Caviar SE 80GB 8MB ATA100 WD800JB - - - FSP 350W PSU

GA 7VT600 1394 Can someone tell me if this is the correct sensor for the case temp-sis950/ITE8705F 1? I believe this is the one for the CPU but not sure about the other, sis950/ITE8705F 3diode. There is another sensor, sis950/ITE8705F 2, which reports 28C. This is more in line with what a...

does anyone know if the 8knxp ultra64 w/ bios version f6 supports ddr2? thanks.

Does anyone know if the new Gigabyte GA-K8NXP-9 nForce4 Ultra motherboard can have a Thermalright XP-120 installed?, and installed WITH the DPS daugthercard installed also? http://www.hardcoreware.net/reviews/review-250-4.htm You see the DPS card just above the CPU retention socket, how does...

Hi, I had to replace my GA-7N400-L1, useless after a bios update, with a GA-700N-L yesterday. I have an AMD 2600 CPU with supplied fan and heat sink on the machine. I was browsing through the posts here for any info on this later m/board and read about CPU temps.. I checked the temps on this...

Hi My brand new motherboard doesn't boot. the configuration is ATHLON 64 3000+ , 512MB PC3200 KINGSTON KVR400, HD MAXTOR 120GB 7200. The system power on, I measure the power supply voltage ok, no beep message cpu fan running, but the display remain blank Do you have any suggestion Thanks Kinse

Hi Peop's Ref @BIOS for GA-81PE1000 Pro2 I just run @BIOS and it comlained that it thought it was out of date and that i should get the newer version from "The Website" but it failed to tell me where exactly, could someone point me in the right direction please? --

A crack, and the machine powering down, then a hint of fried semiconductor in the air... it looks like one of the voltage regulators on my GA7VRXP has cratered. Is this a common problem with these boards? I suspect one of the nearby electrolytics has failed, and I think it may have taken the CPU...

Hi, having a bit of trouble with my oldest PC. Just replaced the cpu fan + it won't boot, just gets to 'Checking Nvram...' and stops there. Can't get into Bios + there are no error code beeps so am unsure what I've done. Checked Cpu to see whether I'd inadvertently crushed it but it appears...

I have a GA8IEXP rev 1.2 It used to have firewire, but all entries for it have disappeared from device manager, I guess since XP SP2. Any ideas how I get firewire back again? Thanks. --

For those that havent been nailed by this yet, I offer some caution. I have a 7n400 with the Gigaraid controller. While using the gigabyte drivers for 2000, I ran windows update. I saw that there was a new drive for the ITE ... so I downloaded it. Well ... its the drive for the regular IDE...