The Asus website is down and I am trying to find out if PC-8500 Corsair TwinX will work good in the board. Anyone know? TIA. -- -

I have installed a new P5K WS motherboard with a Sunbeam Core-Contact Freezer cooler. The fan for the cooler is a bit loud (it runs at 2000 rpm); unable to see how to modulate the fan speed, I disconnected it for a test. Running BurnIn for 60 minutes with the cooler with the fan blowing through...

I think I know the answer already.... but can my P4P800-E accept one of the new dual-core CPUs? Just got one of HP's at work and now my home box feels soooo slow.... -) -- PeteCresswell

I have installed a new copy of WinXP Pro-64-bit SP2 on an ASUS P5K WS mb and cannot get online to update the operating system. My LAN is working just fine, with a gateway and DHCO server of 192.168.x.yza and all computers are DHCP-assigned. When I plug in my ethernet cable, I receive a message...

Hello All! I have a question regardin max mem freq in dual channel mode. Recently I purchased 1066 MHz DDR2 1Gb - 2pcs. They run nicely on single channel mode (WinXP) but every single time I try to force them into dual channel mode, the freq goes down to 800MHz even that in BIOS I set this freq...

I have an ASUS P5K WS mb and the latest BIOS is 2 MB when unzipped. How is one supposed to flash the upgrade? (this is the BIOS flash guide and is only for a DOS-based procedure)

I am putting together a system with an ASUS P5K WS rev 1.02G. There are two power connectors on the mb: a 24-pin EATXPWR and an 8-pin EATX12V connector. The 8-pin connector has a removable plastic plug that leaves a square configuration 4-pin receptable. I have a Corsair 520HX power supply...

I've read where it was done by adding a waterblock to the northbridge central connection for the heatpipe system. Since the heatpipe principle needs a hot end and a cooler end for the phase change to work, I am a little nervous about trying it. Any idea? Luck;

Asus A7V400-MX motherboard is not showing any display, not even BIOS POST message. This happened a few days ago and I tried plugging in PCI video card, which looked scrambled and then rebooted without it and everything appeared fine. Now the problem arises again. If I disconnect hard drive and...

Ok Here it is ( found in SP3 knoledge base ): if you add a host controller for a new 1394 device to your computer, you must add or modify the SidSpeed entry in the Windows registry for the new 1394 host controller. To do this, follow these steps:1. Click Start, click Run, type regedit, and then...

Today I walked into my living room with the lights out with the new antec case for the first time... And I was happily surprised what I saw: http://members.home.nl/hbthouppermans/DreamPCThirdBuild/AngelPC.JPG ^^^ Angel guarding over me ;) :) ^^^ Now back to some serious stuff:

My P4P800 Deluxe based PC has been serving me well for 4 years. It is still fast enough for the type of work it is used for (office work, Internet access, etc.). However, a few months ago it started acting weirdly: Every now and then (randomly and without the ability to reproduce the problem),...

I am planning a system which will use Win XP 64-bit and want to use a P5K WS board. 1, am I correct that the board supports a 64-bit system? 2. is there any problem with an all-SATA install? do I just need to load the SATA drivers with a floppy? How will my SATA DVD be able to be used to load...

I've been playing with a temperature reporting program, HWMonitor from the guy who jalso publishes cpuz, and it reports a temp from ITE IT87 TMPIN2 that I can't correlate to any device I see. What bothers me is that this reading is consistent and consistently about 20+ degrees higher than any other...

I'm about to get this board most likely.. the p5e3 deluxe, which takes ddr3 memory.. I cant find the module i was going to buy in their memory specs/ recommendations, but i think it should be fine.. What 2GB 1333 is everyone using in this board.. would ocz special ops (9-9-9-27) be ok?

I'm currently using an Asus P5B Plus with an older Conroe running at 2.13 GHz. 4 Gig DDR2-800 memory. The P5B uses the Intel P965 chipset and claims to support 1066/800/533 system bus speeds. I now see all sorts of Core 2 Duo and Quad offerings, but I'm pretty sure my older motherboard poses...

Nice looking board, I am hoping for a nehalem board that hasn't got IDE or PCI connectors. PCI express completely would be great.

Allo Has someone tried to change the awful looking of that board's login screen, using MyLogo - directly or through Update.exe. I have a collection images I would like to substitute to the opening screen, but MyLogo does not detect any of them. They are *.BMP, *.JPG,*.TIFF in various...

Hello there. I have novice question about PCIe. I am looking at Asus M3A32-MVP Deluxe AMD board. It has 4 PCIe x 16 slots + 2 PCI slots. No PCIe x1 slot. I have device that need PCIe x1 slot. (Which is TV tuner card) My question is that can I connect PCIe x1 device on PCIe x16 slot? Will it...

I've flashed my P4P800 Deluxe to 2.51, and thought there'd now be an option to boot from usb device. But I can't find any way to enable that. I see ref's to it here in the ng. The boot menu does not offer a list of hdd, but does have the boot device order options (3) which are currently CD,...