A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » System Manufacturers & Vendors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Compaq Servers Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
Proliant 3092 Raid Enclosure by Burnt Eddy
Hi, Just got a Proliant Series 3092 Raid Enclosure and am having a hard time finding any documentation. Does anyone know where I can get it or have the Part No. for the manual so I can download from ftp.compaq.com????
March 15th 05 09:05 PM
by Nut Cracker Go to last post
7 152
Compaq 1600 scsi raid nightmare! Please Help by Buzz
Hi Gang, I been reading your form for the last few days looking for a solution, (other than beating on this with a big hammer.) System: Proliant 1600r 2 450 cpus, 512 menory, 2sl raid card, 5 compaq scsi 10K drives in internal bay Running 2000 server. All was fine till a few days ago the the...
January 31st 05 02:33 PM
by Buzz Go to last post
0 287
1600 help on last straw here by Buzz
Hi Gang, I been reading your form for the last few days looking for a solution, (other than beating on this with a big hammer.) System: Proliant 1600r 2 450 cpus, 512 menory, 2sl raid card, 5 compaq scsi 10K drives in internal bay Running 2000 server. All was fine till a few days ago the the...
January 31st 05 02:41 PM
by Buzz Go to last post
0 297
Do all compaq monitors fit each other? by [email protected]
Can you use any compaq monitor on other compaqs? I keep getting replace hard drive because of eminent failure message so was just thinking of getting the package that has the tower keyboard and mouse at wal mart and save since the monitor is still working.
May 27th 06 04:32 AM
by [email protected] Go to last post
7 345
HP Power Jack Problem, I Fix it for You by Carl97
Many HP Laptops from several batches have a defect in production, it is down to poor solder welds on the motherboard at the manufacturing stage, Many of the problems happen after the warranty runs out. I don't want to imply anything but I have seen similar problems with HP in the past where I...
July 15th 06 12:39 AM
by Rick F. Go to last post
1 690
overlapping a disk in 2 arrays - Proliant ML350G3 by [email protected]
Hello, We've got an interesting problem with a Compaq Proliant ML350G3 with the smartarray 532 controller. It has 4 physical 36GB drives in the SCSI slots. I'm trying to sort out a configuration that was done by a previous sysadmin that looks a bit botched. Specifically - although the machine has...
(Multi-page thread 1 2)
June 2nd 05 05:23 AM
by Carl Brewer Go to last post
13 457
Compaq Pres. 7360-No operating System Found-Error by Carol
Everytime I try to boot up my elderly Dads pc, after the red Compaq letters, he gets a "no operating system found" error. I've tried using the quickrestore CD's, but all it does is pop up a screen that says "quickrestore", and just blinks forever and goes no further. I build PC's, so this is really...
November 14th 03 07:45 AM
by Carol Go to last post
0 331
Newbee help on a Proliant 1850R server by cat1947
I thought I knew a little about computers until I bought this 1850R to learn more about servers and raid setup. Well I am finding I don't really know anything. I am hoping I can get some assistance here. My first problem is there is only one hard drive in this unit right now and I would just like...
(Multi-page thread 1 2)
October 28th 04 07:49 PM
by cat1947 Go to last post
11 281
hard drive size on Proliant 1850r by cat1947
I have a smart array 3200. Does someone know the largest hard drive that this array with see. Thanks Andy
November 5th 04 01:25 AM
by NuTCrAcKeR Go to last post
3 195
Any RAID Box That Will Work With QLogic 2200F by CHANGE USERNAME TO westes
Does Compaq make any RAID box that takes the standard Compaq hotswap trays and allows clients to connect to logical volumes using third party fibre channel cards like QLogic 2200F? The older Compaq Fibre Channel Array RAID cabinet is totally proprietary and only works with Compaq fibre cards,...
August 3rd 04 01:44 AM
by NuTCrAcKeR Go to last post
3 454
Proliant 6400R Does Not Show Up in Windows 2000 as Multiprocessor by CHANGE USERNAME TO westes
We have a Proliant 6400R with four processors installed and 4GB of memory that we wanted to run Windows 2000 on. We installed Windows, and configured devices, without a problem. But for some reason the install did not see the additional processors and installed just a single processor model...
February 24th 04 02:23 AM
by beldar Go to last post
5 735
Full Table and Full Table - Mapped Hardware Configuration Options by CHANGE USERNAME TO westes
Can someone please explain the difference between the following two APIC settings, found on many Compaq Proliant servers: Full Table Full Table - Mapped What is the implication of each setting with reference to multiprocessor use under Windows 2000? Which is generally the preferred setting for...
February 24th 04 10:53 PM
by nut cracker Go to last post
1 1,213
Drives Not Autostarting in a 4214R by CHANGE USERNAME TO westes
We have a fair number of Compaq 4214R U2 hotswap drive cases. The behavior I normally see is that when you insert a hotswap drive into one of these cases, it autorotates, and at that point it can then be seen on the SCSI bus by the attached host computer. On one 4214R I just installed, when I...
(Multi-page thread 1 2 3)
June 3rd 04 05:14 AM
by NuTCrAcKeR Go to last post
25 1,994
144 vs 288 megabit Rambus Memory in W8000 by CHANGE USERNAME TO westes
How significant is the effective performance difference between 144 Mb and 288 Mb RAMBUS memory in the Compaq W8000? Why don't they allow 288 Mb memory in all four memory slot pairs? -- Will westes AT earthbroadcast.com
August 8th 04 03:02 AM
by CHANGE USERNAME TO westes Go to last post
0 708
ATI RADEON 9800 Pro in W8000 by CHANGE USERNAME TO westes
Has anyone had any luck with using the ATI RADEON 9800 Pro 256 MB in a Compaq Professional Workstation W8000? I have the 128 MB version working fine in a dual 2.4 GHz processor W8000. I recently purchased a dual 2.8 GHz processor system as an upgrade, and I tried to install the 256 MB version into...
August 8th 04 02:59 AM
by CHANGE USERNAME TO westes Go to last post
0 343
All PCI Devices Mapped to IRQ 11 by CHANGE USERNAME TO westes
On an SP700 Professional Workstation, all of the PCI boards are showing in the Compaq BIOS as being mapped to IRQ 11. Is that just a convention when the IRQs get mapped dynamically, or is that a problem that I need to correct, and if so how do I adjust the assignments? -- Will westes AT...
August 5th 04 05:52 PM
by Nut Cracker Go to last post
1 341
Is a faster Array Controller & disks worth it? by Chocolate
Hi, I have just got a couple of 2nd hand 1850R servers. The 1999 documentation indicates that the backplane is Ultra2. In one of the servers is a 221 controller, and in the other a 3200. These are both Ultra2 cards. Both machines have 2x9 Ultra2 disks, which I'm happy to keep. My question is, is...
February 24th 04 10:51 PM
by nut cracker Go to last post
1 437
req: smartstart for proliant 5500 by chowumba
hi does anyone have an sio of this disk to download? thanks in advance chowumba
July 3rd 04 12:57 AM
by NuTCrAcKeR Go to last post
1 509
Compaq Presarrio by ChrisB
A friend has a Compaq Presarrio (500 model I think). He cannot get it to switch on. The power supply lights up but the laptop is dead, whether he uses battery or mains. Any idea what this can be? Many thanks
January 14th 05 01:54 PM
by ChrisB Go to last post
0 135
proliant 2500 and solaris 9 by Christer Solskogen
anyone tried if this will work? any cavecheats?
January 22nd 04 01:43 PM
by Christer Solskogen Go to last post
2 528
Post New Thread


Display Options
Showing threads 101 to 120 of 853
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:56 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.