|
|
|
|
1 |
463 |
|
|
|
|
7 |
341 |
|
|
|
|
3 |
511 |
|
|
GA-8KNXP Not Booting up by
DND
Heres whats happening My Kid has a P4S8X-X and the monitor went black
so I had a look and restarted it and it woundn't startup just stayed
black not beeps nuttin so I thought the celron 2.6 had die , So I put
the cpu in my GA-8KNXP and it started up no problem so next I tryed the
videocard I put it...
|
February 12th 06 08:32 PM
by Davy
|
1 |
377 |
|
|
GA-965P-S3 and NVIDIA GeForce 7950 GX2 by
dobey
Anyone using this combination?
I am considering matching these two, and while they should probably work
together Nvidia doesn't list this specific board as tested but the
GA-965P-DQ6 is listed.
Both being Intel 965P chipsets, it doesn't seem likely there will be any
issues, but as you can...
|
September 3rd 06 08:47 PM
by dobey
|
0 |
476 |
|
|
GA-M51GM-S2G by
dobey
http://www.gigabyte.com.tw/Products/Motherboard/Products_Spec.aspx?ClassValue=Motherboard&ProductID=2281&ProductName=GA-M51GM-S2G
Thinking about getting one of these boards and have heard of a few problems
with the nforce4 controller.
I am currently using an Abit NF7-S, (nforce2), and haven't...
|
June 24th 06 11:45 AM
by JK
|
3 |
346 |
|
|
8IRXP and "OLD" reboot, BIOS problem by
Doc
hey John,
Would 'cha believe my old faithful Matrox G400 dH just died
in this board. Now I do have to "buy" something.
ANYONE put a RADEON 9100 into the 8IRXP?
Believe it fits the '1.5 voltage specs (right?)
I'll post in a separate 'video' inquiry. Thanks.
John said this:
|
July 21st 03 06:46 PM
by John
|
1 |
844 |
|
|
8IRXP OCed to 150 FSB, but RAM? by
Doc
Had this GB 8IRXP since the 'reboot' problems and so far I'm
okay with 'shutting down' instead of 'restarting'. It is a bit
long in the tooth but I cannot afford to replace it yet.
I've got a 1.6 OCed to 2.4 (FSB at 150) but the DDR is 2100 (good
stuff from Mushkin) and won't do the full 150......
|
December 30th 03 07:53 PM
by Doc
|
9 |
496 |
|
|
Setting up cheap RAID. Advice on drives by
doddie
Got a Gigabyte S775 Intel P35 DS3 REV2 wanting to setup a raid using 2x
160GB SATAII
Can anyone recommend make/model of drives to get, reliable? my budget is
about 60 quid
seen this one from Amazon ...
Maxtor 250GB S/ATA2 7200rpm 8MB Cache, SATA 300 Hard Drive
£30.99
( 1 2)
|
April 27th 08 06:14 AM
by DCA
|
12 |
870 |
|
|
Heat sink for Pentium 4, fan replacement ? by
Dodgr Rereksin
Is there a heatsink for the pentium 4 chip that will replace the fan, and
its noise unnecesary? I'd like to reduce PC fan noises, and this seems
reasonable, but not necessarily so. My pentium 4 is 3.0 GH and my MB is
8knxp Ultra? This is my first time I've spent anytime looking into this
question,...
|
|
1 |
255 |
|
|
GA-8KNXP and ITE IT8212 controller by
Dodgr Rereksin
This answer while maybe true is disturbing. My experimentation with SATA
drives is they don't respond well to Powerquest's Drive Image software, my
main means for backing up and restoring hard drives.
Only Use Hard Drives with this Controller..
Use on onboard IDE ports for CD Rom..
|
April 4th 04 01:07 AM
by Tim
|
1 |
202 |
|
|
8knxp internal sound card by
Dodgr Rereksin
In its default jumpered (2 jumpers) configuration, I found that sound output
at the rear was mono, the second channel was silent. I took the jumpers out
and attached the wires from the front panel sound jack to the MB sound pins
, and I got two channel normal output. Has anyone had this type of...
|
|
1 |
429 |
|
|
SATA drive causes blue screen of death by
Dodgr Rereksin
My boot/system drive is SCSI and my multimedia drive is SATA. Most but not
all the time when I start the system with the SATA setup in Auto mode, I get
the blue screen of death immediately when my username and password are being
checked. When I don't get the BSOD, personal settings load next, and...
|
|
3 |
609 |
|
|
8KNXP, F12 bios and CPU temperature. by
Dodgy
I just flashed my 8KNXP board from F6a to F12 (to support the newer,
faster P4 I'd bought).
Everything is working fine, except Motherboard monitor, which used to
behave normally with F6a, now seems to show CPU temperatures jumping
about wildly.
52 one reading, 59 the next, back to 53 then 60, then...
|
|
1 |
161 |
|
|
Odd sound problem with 8KNXP by
Dodgy
Windows XP decided to eat it's registry on friday so I had to do a
complete ground up reinstall of my machine over the weekend.
I downloaded all the latest drivers from the gigabyte website for my
rev1 8KNXP, and everything is now fine, except one little annoying
niggle.
When I move the system...
|
August 30th 05 01:19 PM
by Dodgy
|
9 |
305 |
|
|
Help with 1999 hardware? by
Dom
Hi
A frind of mine is on a budget and his PC keeps chugging happily along with
an AMD K6II in a Gigabytre GA-5ax mobo rev. 5 and latest BIOS.
(By 'latest BIOS' I mean F4, from autumn 2000, tee hee.) It is claimed that
version BIOS supports up to 64 Gig hard disks. I think the fatstest the...
|
December 11th 03 02:57 AM
by Frank
|
4 |
264 |
|
|
8knxp and P4 3.4C by
Domenico Andreoli
hi all,
i'm wondering whether mobo 8knxp rev 2 supports p4 3.4C or not. if not,
does it support 3.2C? how to know which is the maximum freq it supports?
many thanks
domenico
-----http://people.debian.org/~cavok/gpgkey.asc
---[ 3A0F 2F80 F79C 678A 8936 4FEE 0677 9033 A20E BC50
|
|
3 |
309 |
|
|
Ga 8knxp ver No by
Domenico Andreoli
William Smyth wrote:
hi all
hi
how can you tell ver No you have for
the ga 8knxp v1.00/v2.00
topic already discussed here.
http://groups.google.it/groups?hl=it&lr=&ie=UTF-8&oe=UTF-8&selm=re1ipv4g0rjntvl01kg9ljkpb86sa2k681%404ax.com
|
|
1 |
484 |
|
|
GA-8KNXP rev 2.0 + OCZ EL DDR PC-3200 Dual Channel Platinum by
Domenico Andreoli
hi all there,
i just bought a GA-8KNXP rev 2.0, of course i read about its memory
problems only a couple of hours after package arrived.. :/
now i have to choose the ram to installe. i'm thinking at ocz memories
in subjects. anybody has reported any success with them? any other
suggestion? any...
|
|
8 |
588 |
|
|
|
|
24 |
1,016 |