A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
7VTXH+ by E_\\_¼__½__¾__F
I just bought a new in the box 7VTHX+ mobo and got it installed. everything went well except for the sound. On a fresh install of winxp the onboard sound is scratchy and distorted badly. I even downloaded the newest drivers from the gigabyte and installed the newest 4in1 pack with no...
September 25th 03 03:09 AM
by E_\\_¼__½__¾__F Go to last post
1 180
7VTXH+ - Bad BIOS Flash by Orange Barrel
I am in BIOS hell. Through a comedy of errors, I have managed to trash the main and backup BIOS on a 7VTXH+. To add insult to injury, I ordered two pre-flashed BIOS chips from BadFlash.com only to find out after the fact that the original BIOS chips are soldered to the mobo. Bleh. In any event,...
September 29th 04 01:08 PM
by Orange Barrel Go to last post
0 542
7ZXE makes rattling noise by Igor Matlin
Hi, I got a problem with a friend's GA-7ZXE v1.1. The motherboard makes a rattling noise through the speaker, and won't boot. CPU fan and str-led come on; drives don't seem to get initialized; hdd led stays on. Obvious things like removing everything except CPU, RAM, and video or pulling out...
February 18th 04 03:09 PM
by Igor Matlin Go to last post
0 475
8 Beep problem by Chris Klonaridis
Got a Socket A Board. When i switch in on, it beeps 8 times. what is the beeping mean. thanks chris
February 18th 04 07:42 PM
by Mart Go to last post
1 125
8 IDML motherboard ... help by Aamir
AOA; i am using 40 GB harddisk on 8IDML motherboard but when i connecte d 120 GB segate harddisk it worked fine but when i connect both 120 GB and 40 GB only 40 GB was detected !! why ?? how can i connect both hdd's? Whats max limit for hdds on this board? Any suggestion about this board will be...
December 29th 04 08:41 AM
by Aamir Go to last post
2 259
8 weeks delivery time for ordered slot-cables by franz47
I purchased a Gigabyte mainboard in December 2008. Serial etc. cable to slot is not standard equipment any more. I contacted Gigabyte and they promised to send the missing stuff. Now 8 (eight) months later it arrived. Unbelievable, but true. If you really really need that, apparenty don`t expect...
August 28th 09 09:28 PM
by franz47 Go to last post
0 723
8-IRXP by Jens Koehne
Hello, What processors can i use with this board. Is it possible to use 533 MHz FSB?? Thank“s Jens
April 19th 04 05:00 PM
by Jens Koehne Go to last post
0 164
80 Wire vs 40 Wire for DVD burner and CDROM by Striker
Can I use a 80 wire ribbon cable with my DVD burner and CDRom or should I use a 40 wire cable? Are there any advantages or disadvantages to either one? Thanks,
January 26th 04 07:58 PM
by +CrimsonLiar Go to last post
3 1,100
800Mhz Pentium on GA-8SQ800 by iloop
Hello all, When the GA-8SQ800 came out, Giga-byte said it (or rather, the SiS 655) will have support for the 800Mhz Pentiums. Does anyone know if this is indeed the situation? if it is not, is Giga-byte/SiS actually working on it, or will 533 be the best I can get? Thanks, Uri
September 8th 03 11:07 PM
by jamie harding Go to last post
1 381
81915P DriverIRQL Not Less or Equal by Reay Family
I have put together a new system that crashes with the above error when testing the CMI9880 speakers, and sometimes at randomn. Seems okay if only one jack used, but crashes when second set of speakers are plugged in and tested - using the Audio configuration utility. I have reloaded with...
January 4th 05 09:30 AM
by Mercury Go to last post
2 161
81955x Pro can't use 56k PCI modem.... by DebB
I can't get either of my 56k PCI modems to fully connect to my ISP on the 81955x Pro m/board. They're fine elsewhere. When I dial it's ok, then it takes forever to handshake and emits a sqeal for about 30 seconds, then after it's verified username and password (which also takes far longer than...
August 14th 05 06:14 AM
by DebB Go to last post
0 200
81EXP r1.2 processor by Safari Sam
Anyone have one of these boards running a 3 ghz P4?
June 21st 05 07:32 PM
by Safari Sam Go to last post
0 273
81NXP for sale (toronto) by La Pedrera
I am selling this board. I've upgraded to something supporting the 800 bus. Board is approximately 4 months old. 225$ Also selling my Pentium IV 1.8 CPU. 140$
July 27th 03 05:08 AM
by La Pedrera Go to last post
0 1,199
81PE1000 turns itself on by BillM
Anyone know why my new 81PE1000 865PE turns itself on, sometimes, after a hard off? Not immediately and not all the time but sometimes it waits a while or a day and bingo turns on and boots. I run XP Pro and have some scheduled tasks that are scheduled over night. Bill
October 8th 03 08:51 PM
by Joe F. Blow Go to last post
2 341
845pe & P4 800 mhz support? by Moosey
Hi I'm curious to know if anyone has tried using a 800mhz bus P4 & a 845pe chipset motherboard (especially the 667 ultra2). If so, what settings did you use? Thanks
November 15th 03 11:04 AM
by Driekes Go to last post
4 304
865G graphics driver problem by EA
Hello, I have the GA-8ig1000g-pro board with the 865G chipset with 98se installed. Was having a problem of not being able to restart the machine from windows, I could shutdown but not restart through the start menu - the machine would hang on the final splashscreen. So I changed to standard vga...
September 3rd 04 12:52 AM
by EA Go to last post
0 298
8ge667 dimm problem by donkthemagicllama
I've got a rock solid system with an 8ge667. It's got a 512 DDR333 dimm in it. I attempted to add another 512 dimm (same manufacturer... Kingston, same speed, same timings, although it doesn't look identical... there's some capacitors in different places etc.), and now my PC hangs before it...
November 19th 03 06:17 PM
by donkthemagicllama Go to last post
2 185
8GPNXP DUO Boot Problem by AKAeric
I just upgraded my computer. New processor, Motherboard, and Graphics Card. Specs: Intel P4 3.0GHz Socket T Gigabyte GA-8GPNXP DUO X800PRO 256MB 256-bit 1.5GB GeIL DDR3200 160GB Samsung IDE 20GB Quantum Fireball IDE
June 25th 05 08:35 PM
by AKAeric Go to last post
0 347
8GPNXP-duo-Memory Frequency by research
Hello, I have an 8gpnxp-duo with 2 corsair DDR2-PC5400 Modules(2X512Mb-matched pair). In the manual Gigabyte discribes how to set the memory frequency to 3 times host clock, but in my bios (F5) I only see 1.66, 2.00 2.66 and AUTO. When set to AUTO the frequency is 2.66 x hostclock(200Mhz) and...
December 4th 04 09:55 AM
by SteveK Go to last post
3 184
8i775-G problem, need help by hkl
The manual for this board documents a setting in BIOS where I can set the memory speed multiplier as follows: main menufrequency/voltage control"memory Frequency for" manual shows 4 settings for FSB = 800 Mhz: 2.0, 1.6, 1.33, auto But when I go into BIOS it shows only 2.0 and auto. I must run...
June 28th 05 08:36 PM
by JDR Go to last post
1 248
Post New Thread


Display Options
Showing threads 141 to 160 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 09:39 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.