A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
The amazing disapearing RAID Array (K8NS Ultra 939) by [email protected]
I have an SATA RAID 0 Array set up on the Silicon Image controller using 2 samsung HD160JJ hard drives as the 'D' drive. All ran fine until I recently updated the SATA raid driver. I went from 1033 to 1052 (tried 1053 too) and the 'D' drive disappears! The drive does not even show up in the disk...
February 4th 06 10:12 AM
by [email protected] Go to last post
0 272
8KNXP: How to Enable IDE 3 & 4? by Si
I have 4 hard drives and at the moment 2 of them are plugged into a card in a PCI slot. I now need that slot for something else, so I need to plug the drives into IDE 3 and 4. According to the manual, I need to enable these in the BIOS but I am not sure which setting it is. So if anyone can...
February 4th 06 01:26 AM
by Jeff French Go to last post
8 291
GA-K8NS memory problem by user22
Ok, first off, this is a socket 754 mobo and not the 939 one with the same name. It has 3 dimm slots. Ive been running it with 2 DS 512 pc2700 sticks at 333 with no problem. I recently got a few sets of pc3200 sticks to upgrade to. They are corsair 2x512 matched pair and Patriot 2x512 matched pair....
February 2nd 06 05:52 AM
by user22 Go to last post
2 386
onboard USB power issue? by RoyB
I have an external laptop HD in one of those neat USB cases. MB is a Gigabyte 8IRXP. When connected to the USB2 ports on the rear panel the device correctly powers up via the USB port VCC. When connected to an added USB port via the mainboard jack it works but only if I provide external power. ...
February 1st 06 10:45 PM
by Peter R Cook Go to last post
1 254
XP can't find hard drives to install by AKA gray asphalt
When I try to install XP the setup says that it can't find any hard drives. The CD is on IDE 1 and the drives are on IDE 2. One has an old version of XP that I want to delete. The instructions say that the CD should be on IDE 1.
(Multi-page thread 1 2)
January 31st 06 09:52 PM
by AKA gray asphalt Go to last post
12 483
Get Rich by Daun Johnson
Follow the directions below and in two weeks you'll have up to $20000.00 in your PayPal account. There is a very high rate of participation in the program because of its low investment and high rate of return. Just $5.00 to one person! THAT'S ALL !!! If you are a skeptic and don't think the...
January 31st 06 04:16 PM
by Daun Johnson Go to last post
0 326
Get Rich by Daun Johnson
Take advantage of a great deal
January 30th 06 11:52 PM
by Daun Johnson Go to last post
0 588
Agp settings on GA-7DXE... by Snooksy
Microsoft Windows XP Professional Service Pack 2 (Build 2600) System Memory 768.5 AMD AMD Athlon(tm) XP 2000+ 1675.1 Display Device NVIDIA GeForce 6200 Display Memory 256.0 Display Driver 6.14.10.7801 Motherboard Manufacturer: Gigabyte Technology Co., Ltd. Motherboard Model: GA-7DXE Hi there i was...
January 29th 06 10:55 PM
by BigVoice Go to last post
1 251
nwK ***Hot stuff - check this out !!! nwK by tinman4
http://www.kaneva.com/checkout/stream.aspx?assetId=2017&free=0
January 29th 06 08:08 PM
by Dick Groen Go to last post
1 374
GA-K8N Ultra-9 - Memory Speed Problem by Chalkie
Hi My motherboard is GA-K8N Ultra-9 with a Athlon 64(Venice)3500 and I am trying to run 2x Corsair (TWINX1024-3200C2PT)DDR400, that's 4 matching 512 modules. The problem is since I added the extra 2 modules the speed has gone from 400 to 333 in the BIOS. Can you help? Thanks
January 24th 06 09:39 PM
by Gerald Todd Go to last post
2 240
Re Router. B59G by Jonno
This router is not allowing me to change the SSID when I want/need to. Any idea why this is ? Gigabyte have no iota of whats causing this... Any one else have the problem?
January 24th 06 09:19 AM
by Jonno Go to last post
0 240
XP won't recognize Gigabyte RAID drives by AKA gray asphalt
I'm trying to restate this with a better subject .... please see message above. Thanks.
January 23rd 06 02:43 AM
by Jonno Go to last post
1 405
GigaRaid Manager by X
Restored from backup after some major battles with my board drivers etc. All back to OK status but the GigaRaid Manager won't run in XP, I checked and the correct version of drivers are installed ITE IT8212 v1.6.1.8. If anyone has stumpled on a solution for this then please let me know, any help...
January 23rd 06 02:17 AM
by X Go to last post
1 268
disappearing Optical drive on 8KNXP by EtienneD
Hello, I got a strange behavior with my 8KNXP rev1 (winXp pro sp2) and, I think, probably at Bios level (last one F13): I use the primary Ide for one Ata drive and the secondary Ide for two optical drives (DVD and CD). Sometimes, the slave optical drive (on secondary Ide) disappears and the only
January 23rd 06 12:03 AM
by EtienneD Go to last post
4 217
Trouble Changing RAM by [email protected]
I am trying to upgrademy machine from 1 GB (2x512 sticks) to 3 GB (3x1024). The motherboard is a K8NS Pro. Each stick is DDR 1GB, 400MHz, CL3. So, here's the situation. When I install just a single GB stick and power up, it boots. I've tried with each stick and it works. However, when I power...
January 22nd 06 10:11 PM
by X Go to last post
3 213
help needed ga-8l848p775-g by matt wicks
have installed this with a\ pentium 4 3.6ghz processor everything was going ok it booted up and saw all my peripherals then sjuddenly stopped giving a continuous series of short beeps - the manual indicates that this is a power problem - so i have a new power pack - tried on 350w and 500w i...
January 21st 06 09:12 PM
by matt wicks Go to last post
0 274
Gigabyte tech support by AKA gray asphalt
Is there any phone support for gigabyte? Doesn't anyone here have a board with onboard RAID. I'm stuck with two computers that won't recognize hard drives or CDs. Please help : -)
January 21st 06 06:31 AM
by AKA gray asphalt Go to last post
0 415
Adding a HD by Mickey Mouse
I have a WD 200GIG Hardrive in my old machine. Mobo died. The hardrive was formatted to C: drive (no partitions) I want to add this drive to my new system My new system uses a K8 Triton Series Mobo. Gigabyte Ga-k8nsc-939. And dual Core AMD,Athlon(k7) processor. System is running Windows Home +...
January 20th 06 06:26 AM
by Beowulf Go to last post
1 303
GA-7N400 Pro2 use of IDE3/4 for HD Help by Ockerr
I have a Gigabyte GA_7N400 Pro 2 Mother Board XP Pro is installed on a Sata 160 gig Drive on the IDE1 connection I have a CDwriter On IDE2 conection I have a DVDwriter as Master and a 40gig Drive as slave. At the moment IDE3 and IDE4 Raid is empty. I have 2 spare 40 Gig Drives that I would like to...
January 20th 06 12:11 AM
by jpsga Go to last post
8 358
GA-6WMM7 - busted VGA connector by Philip Herlihy
A friend has asked me to look at her PC. The VGA connector (integrated onto the motherboard) has been bashed, and now rattles around loosely. Photos: http://www.walthamsoft.net/mobo/mobo-woes.htm This and other connectors are integrated onto the board. If I can remove the one on top (the pink...
January 18th 06 07:35 PM
by Philip Herlihy Go to last post
1 345
Post New Thread


Display Options
Showing threads 901 to 920 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 03:31 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.