A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
GA-7DXR - Turn off RAID ? by Rich Hare
I've got a GA-7DXR which I am running without using the RAID ports. I understand that some motherboards have switches which allow you to use the RAID ports as conventional IDE ports. Is there any way of doing this on the GA-7DXR? I don't see it in the manual, and can't find anything in the...
July 31st 03 01:46 PM
by Rich Hare Go to last post
2 384
GA-7VAXP-Ultra Bios hidden settings by Tom
Can someone tell me how to access the hidden bios screen on this MB. I forgot how to do it.. Thanks Tom
July 31st 03 12:27 PM
by Oliver Go to last post
1 392
lifespan of the athlon compared to P4? by Roger Hamlett
"Iain" wrote in message ... I am getting a new gigabyte mobo (with the help of the good people in this ng) and read last night while researching the subject that the Barton core on the Athlon XP is likely...
July 31st 03 02:59 AM
by S.Heenan Go to last post
3 540
GA-8KNXP & motherboard monitor? by Ken
What other motherboard monitor prog do people use for this board? The easy4tune prog that comes with it wont load on this machine. So have to use another one. Ken
July 31st 03 02:36 AM
by Tim Go to last post
8 641
upgrading to a gigabyte board - a few queries by Iain Robinson
I'm ditching my Abit KT7-Raid and 1.1GHz TB and thinking of going for a Gigabyte GA-7N400-L1 and a 2500+ Athlon XP (333MHz Barton core) with PC2700 RAM as it's a reasonably priced combination. I just have a few questions before I get the credit card out; 1. Does anyone have any comments, good or...
July 31st 03 12:50 AM
by Fred Klingenmeier Go to last post
3 617
PE667 Ultra2 SATA Boot Order Problem by Pete
Hi, I have just bought a 120GB Seagate 7200.7 SATA drive. I temporarily disconnected my old IDE drive, and installed XP on the new one. I then rearranged the existing drives to the following configuration: IDE1 Master - DVD ROM Drive IDE2 Master - CD Writer IDE3 Master - Seagate Barracuda IV (Old...
July 31st 03 12:47 AM
by Sir ScissorClaw Go to last post
1 876
7N400-L1 by galaxy
Hi, Has anyone tried installing a GA-7N400-L1 motherboard with Windows 98 Second Edition? The driver CD does not seem to have some of the drivers on it. There is no sound driver for 98 on the disk and other drivers seem to not work correctly with 98....anyone had this experience? Thank you
July 30th 03 10:03 PM
by galaxy Go to last post
0 315
GA-7NNXP and the Barton 2800xp Chip by S.Heenan
Steven A Stevenson wrote: Anyone running this combo? The system post only list the CPU speed at 1250 Mhz? Bios update needed maybe? The FSB is set 100MHz from the factory. You will need to change that to 166MHz. Set CLK_SW to the On position. See page 16 of the manual. -- Winerr 00B - Push...
July 30th 03 04:54 PM
by S.Heenan Go to last post
0 362
switch to RAID, re-install XP? by Hervey Cleckley
I am installing a second WD120 for RAID. I assume it is best to do a clean install? Can it be done with current file system intact? Thanks GA-7N400 Pro ver. 1.0 2500 Barton 256x2 Abit Siluru geforce BIOS ver. f9
July 30th 03 11:26 AM
by Hervey Cleckley Go to last post
5 361
GA-7N400-L and GA-7N400-L1?! by Gameł
Hello everybody, I am trying to understand the difference between the two motherboards, but they basically look the same. Any suggestions? Best regards. -- Preferirei essere chiamato genio di male...
July 30th 03 07:51 AM
by Gameł Go to last post
0 372
Disappearing SATA drives on GA-8KNXP ? by Ackk
I too had the same problem using ICHR5 and 2 Seagate 120gb SATA in RAID0 with F5 BIOS. I called Gigabyte today and the tech I spoke with said he knew what was wrong, that it was a known issue, and he emailed me BIOS ver F6k which he said wasn't on their website yet. I flashed the BIOS and now the...
July 30th 03 06:56 AM
by Marshall Lai Go to last post
1 1,251
Gigabyte GA-8KNXP vs. ASUS P4C800-E Deluxe by DJ
I have been considering getting an ASUS P4C800-E DELUXE. I've had previous ASUS boards and have always been satisifed with them. My Abit KT7A-Raid was another story. Anyway, I was considering the P4C800-E but recently Tom's Hardware released a review and gave an editor's choice to the...
July 30th 03 06:21 AM
by DJ Go to last post
2 548
GSQ800 problem by Paul Creurer
Computer shuts down after a few minutes. To restart, I have to drain the residual power on the motherboard, before anything starts up (turn power 'off 'on power supply & turn power 'on' on case). I don't see anything obvious wrong. i.e. jammed fan, overheating, etc. P4 2.53 gig GSQ800 MB 1gig...
July 29th 03 09:00 PM
by Paul Creurer Go to last post
0 346
GA-BX2000 Motherboard by Alan Reeve
I've got two IBM 40Gb disks running on my BX200 board using F7 bios. If you send me your e-mail address I can send the file. Al Reeve "steve starkey" wrote in message ... Hi, as a emergency im using a old GA-BX2000...
July 29th 03 06:48 PM
by Alan Reeve Go to last post
0 381
GA-7VAX and onboard NIC failure by Eddie Bromhead
Yes, I had the NIC on a VAXP-A fail after about 2 weeks. I didn't dream it was the mainboard, and spent all day looking at cables, software, drivers etc. It's a lot of hassle to swap a mainboard out just for something that is easily cured with a PCI NIC instead. I've also had network cards just...
July 29th 03 02:14 PM
by Shanon Go to last post
2 370
ga7zx wierd problem after upgrading to winxp by Bill
i just upgraded my win98se to winxp...however when i completely shut down then restart, my keboard has an exclamation next to it...i can uninstall, then restart and i have keboard functionality. Only after i complete shutdown and restart do i get the yellow exclamation point for the...
July 29th 03 10:13 AM
by Geeman Go to last post
1 411
Gigabyte GA-7VAXPand Windows XP by Dennis Alperstedt
Hi, I bought a computer in november last year. All worked fine under Windows2000. Then, i installed Windows XP, because Windows2000 didn't recognized the onBoard-RAID-Controller correctly. But now i have another problem: at my secondary IDE-Channel i connected two devices: a Toshiba SD-M1612...
July 28th 03 10:41 PM
by Eddie Bromhead Go to last post
5 321
GA-7VAC by llywiwr
GA-7VAC I have installed the latest BIOS for this card, but I don't see any options for S.M.A.R.T. capable drives in the set-up - however, during boot-up I notice that it list the hard drives as "S.M.A.R.T. disabled". Is this an oversight on this board, or am I missing something?
July 28th 03 08:39 PM
by llywiwr Go to last post
2 317
GA-686BX and 160GB HD by Reinhard Schuepferling
Reinhard Schuepferling wrote (2003-06-14 10:07:37 PST): Problem fixed. I'm using now an extra IDE-Controller: Promise Utra100 TX2 (30,-EUR) - own drivers (95b-w2003) (no Win-updates necessary)* - hardware-BIOS - works like an SCSI-Adapter-Card with IDE Channels - IRQ-sharing is no...
July 28th 03 11:42 AM
by Reinhard Schuepferling Go to last post
0 625
8inXP and low 3DMark03 Results by Monster
Hello, I have the following,,, Mainboard: Gigabyte 8INXP (latest drivers) CPU: P-4 2.8 Graphics: Creative Blaster 5 FX5200 Ultra (128mb) (latest drivers) RAM: 512 2100 (Crucial Technologies) CD-ROM: Plextor 16/10/40A HDD: 120Gig Western Digital (8mb buffer) Other PCI cards: Hauppauge Win Capure...
July 28th 03 02:40 AM
by Ken Go to last post
2 687
Post New Thread


Display Options
Showing threads 3901 to 3920 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:25 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.