|
|
ga7zx wierd problem after upgrading to winxp by
Bill
i just upgraded my win98se to winxp...however when i completely shut down
then restart, my keboard has an exclamation next to it...i can uninstall,
then restart and i have keboard functionality. Only after i complete
shutdown and restart do i get the yellow exclamation point for the...
|
July 29th 03 10:13 AM
by Geeman
|
1 |
427 |
|
|
GA-7VAX and onboard NIC failure by
Eddie Bromhead
Yes, I had the NIC on a VAXP-A fail after about 2 weeks. I didn't dream it
was the mainboard, and spent all day looking at cables, software, drivers
etc. It's a lot of hassle to swap a mainboard out just for something that is
easily cured with a PCI NIC instead. I've also had network cards just...
|
July 29th 03 02:14 PM
by Shanon
|
2 |
372 |
|
|
GA-BX2000 Motherboard by
Alan Reeve
I've got two IBM 40Gb disks running on my BX200 board using F7 bios. If you
send me your e-mail address I can send the file.
Al Reeve
"steve starkey" wrote in message
...
Hi,
as a emergency im using a old GA-BX2000...
|
|
0 |
396 |
|
|
GSQ800 problem by
Paul Creurer
Computer shuts down after a few minutes. To restart, I have to drain the
residual power on the motherboard, before anything starts up (turn power
'off 'on power supply & turn power 'on' on case).
I don't see anything obvious wrong. i.e. jammed fan, overheating, etc.
P4 2.53 gig
GSQ800 MB
1gig...
|
|
0 |
362 |
|
|
Gigabyte GA-8KNXP vs. ASUS P4C800-E Deluxe by
DJ
I have been considering getting an ASUS P4C800-E DELUXE. I've had
previous ASUS boards and have always been satisifed with them. My Abit
KT7A-Raid was another story.
Anyway, I was considering the P4C800-E but recently Tom's Hardware
released a review and gave an editor's choice to the...
|
July 30th 03 06:21 AM
by DJ
|
2 |
568 |
|
|
Disappearing SATA drives on GA-8KNXP ? by
Ackk
I too had the same problem using ICHR5 and 2 Seagate 120gb SATA in
RAID0 with F5 BIOS. I called Gigabyte today and the tech I spoke with
said he knew what was wrong, that it was a known issue, and he emailed
me BIOS ver F6k which he said wasn't on their website yet. I flashed
the BIOS and now the...
|
|
1 |
1,292 |
|
|
GA-7N400-L and GA-7N400-L1?! by
Gameł
Hello everybody,
I am trying to understand the difference between the two motherboards, but
they basically look the same.
Any suggestions?
Best regards.
--
Preferirei essere chiamato genio di male...
|
July 30th 03 07:51 AM
by Gameł
|
0 |
388 |
|
|
switch to RAID, re-install XP? by
Hervey Cleckley
I am installing a second WD120 for RAID. I assume it is best to do a clean
install? Can it be done with current file system intact?
Thanks
GA-7N400 Pro ver. 1.0
2500 Barton
256x2
Abit Siluru geforce
BIOS ver. f9
|
|
5 |
364 |
|
|
GA-7NNXP and the Barton 2800xp Chip by
S.Heenan
Steven A Stevenson wrote:
Anyone running this combo? The system post only list the CPU speed
at 1250 Mhz? Bios update needed maybe?
The FSB is set 100MHz from the factory. You will need to change that to
166MHz. Set CLK_SW to the On position. See page 16 of the manual.
--
Winerr 00B - Push...
|
|
0 |
367 |
|
|
7N400-L1 by
galaxy
Hi,
Has anyone tried installing a GA-7N400-L1 motherboard with Windows 98 Second
Edition? The driver CD does not seem to have some of the drivers on it.
There is no sound driver for 98 on the disk and other drivers seem to not
work correctly with 98....anyone had this experience?
Thank you
|
July 30th 03 10:03 PM
by galaxy
|
0 |
330 |
|
|
PE667 Ultra2 SATA Boot Order Problem by
Pete
Hi,
I have just bought a 120GB Seagate 7200.7 SATA drive. I temporarily
disconnected my old IDE drive, and installed XP on the new one. I then
rearranged the existing drives to the following configuration:
IDE1 Master - DVD ROM Drive
IDE2 Master - CD Writer
IDE3 Master - Seagate Barracuda IV (Old...
|
|
1 |
903 |
|
|
upgrading to a gigabyte board - a few queries by
Iain Robinson
I'm ditching my Abit KT7-Raid and 1.1GHz TB and thinking of going for a
Gigabyte GA-7N400-L1 and a 2500+ Athlon XP (333MHz Barton core) with PC2700
RAM as it's a reasonably priced combination. I just have a few questions
before I get the credit card out;
1. Does anyone have any comments, good or...
|
|
3 |
625 |
|
|
GA-8KNXP & motherboard monitor? by
Ken
What other motherboard monitor prog do people use for this board? The
easy4tune prog that comes with it wont load on this machine. So have to use
another one.
Ken
|
July 31st 03 02:36 AM
by Tim
|
8 |
646 |
|
|
lifespan of the athlon compared to P4? by
Roger Hamlett
"Iain" wrote in message
...
I am getting a new gigabyte mobo (with the help of the good people in
this ng) and read last night while researching the subject that the
Barton core on the Athlon XP is likely...
|
|
3 |
559 |
|
|
|
July 31st 03 12:27 PM
by Oliver
|
1 |
414 |
|
|
GA-7DXR - Turn off RAID ? by
Rich Hare
I've got a GA-7DXR which I am running without using the RAID ports.
I understand that some motherboards have switches which allow you to use
the RAID ports as conventional IDE ports. Is there any way of doing
this on the GA-7DXR? I don't see it in the manual, and can't find
anything in the...
|
|
2 |
402 |
|
|
On board sound by
Ted Kulinski
I tried the integrated sound on a GA-7VAXP. Your board may use the
same chip--I don't know. My 7vaxp was using the realtek driver.
My sound is hooked up to high end stereo. As for fidelity, it sounded
every bit as good as the Aural Vortex which I have used for several
years now.
On Wed, 30 Jul...
|
|
0 |
552 |
|
|
GA7-VAXP CPUproblem by
Jeff
On 31 Jul 2003 15:55:48 -0700, (Mike) wrote:
I have a GA7-VAXP and upgraded from an AMD 2200+ 266 FSB to an AMD
2600+ 333FSB.
The motherboard is not recgonzing the 2600 as a 2600. It is showing it
to be an AMD 2000+. Can anyone help me. Mike
Make sure you set the...
|
August 1st 03 12:33 AM
by Jeff
|
0 |
449 |
|
|
8KNXP - Bios here's F6k - 8knxp.f6k (0/1) by
Ackk
On Mon, 23 Jun 2003 17:53:27 +0000 (UTC), "Boudewijn"
wrote:
Hello,
Just a quick question.
I am using the 8KNXP with a P4, 3Ghz 800FB + Corsair TwixX 3200 - 2 x 256
Currently using F5 Bios. Although the memory is rated as 2/2/2/5, it's not
stable at these timings and,...
|
August 1st 03 12:59 AM
by Ken
|
9 |
811 |
|
|
ga7vaxp ultra sound pause by
billy williams
when i listen to any kind of sound there is a slight half a second pause
before it comes through. this is only through the digital part of it. I
have it hooked to my receiver. I know the receiver is ok. I used to be
able to find the drive for the acl650 that was umm i think 5.00.....3980 ...
|
|
0 |
490 |