|
|
bios version mis-reported in windows by
tlviewer
hello,
ga-k8n ultra-9
After I installed WinXPsp2 (32bit) I used the @Bios utility to go from
F3-F6. The machine works fine, with the bios showing the correct version.
However Apps like CPUZ or SANDRA still show F3. Why? I've never seen this
before with other boards.
Is there any fix, or should...
|
|
5 |
608 |
|
|
GA8-KNXP RAID 0 performance by
jpsga
"Cosmo" wrote in message
...
has anybody an explaination or solution for this (see picture) bad
performance?
i am using a GA8-KNXP, ITE8212 driver 1.4.1.6, Windows XP, 2,8GHz Intel
P4,
Bios F7, two Western...
|
November 21st 03 11:17 PM
by jpsga
|
0 |
607 |
|
|
AMD 64-X2 socket 939 recommendations? by
Harlequin
Looking to upgrade to an AMD 64-X2 4400 and am seeking motherboard
recommendations. It'll be a scratch build, with 2x SATA II x 250-300 GB in
a RAID 0 configuration, a Lite-On DVD/CD burner, a floppy drive (just in
case), 2 GIG of CAS 2-2-2-5 PC3200 DDR, PCI-X-16 NVidia card (not high end,
as...
|
|
8 |
606 |
|
|
GA-8IHXP Rev. 2.1 Available Here by
sig666
Yep. already sold it.
I am running a GA-8KNXP ULTRA now.
When I got the GA-8IHXP you helped me with a SM Bus controller issue.
Thanks again but it is time to move on.
============
McGrandpa wrote:
You're selling yours?! That's the one I have...
|
|
3 |
606 |
|
|
MB Temperature on 8KNXP? by
Eric B.
Hi,
I just picked up a 8KNXP (Rev 2.0) board, and am trying to figure out how to
read the MB temperature. In the bios and in EasyTune the CPU temperature
shows up, but I can't find a temp setting for the actual motherboard (and
hence ambient case temperature) anywhere.
I've installed MBM5, and...
|
|
5 |
605 |
|
|
GA-K8NF-9 hard disk boot order by
Rob Nicholson
I've got a GA-K8NF-9 motherboard and it's running perfectly in the following
config:
o Boot HDD connected to IDE 0:0
o DVD writer connected to IDE 1:0
o DVD reader connected to IDE 1:1
o 2 x 200GB IDE hard disks connected to a PCI IDE RAID controller (IT8212
chipset)
The SATA interfaces are...
|
December 29th 05 11:52 PM
by Paul H
|
3 |
605 |
|
|
Latest Bios downloads ? Please by
Muttley
AFAIK, the three letter BIOS versions are beta versions of the final two
letter version.
AFAIK, BIOS version FAD = beta D of BIOS version FA, and FA is the final
release version.
So the FA version listed on the website is the latest version and is newer
than FAD..
John S.
|
November 13th 03 03:37 PM
by Muttley
|
0 |
604 |
|
|
Worse memory timings with better memory sticks by
Orhan
Hi,
I have a GA-8KNXP (rev 2,BIOS FB)with P4 2.8C(800MHz). I had two
sticks of Kingston KVR400x64C3/256 (3-4-4) running at CAS 2.5 without
any problem until today (DIMM overvoltage +0.1V).
I bought recently a pair of Kingston KVR400x64C3A/512 (3-3-3) and
replaced the older ones. Unfortunately I...
|
September 13th 04 05:49 PM
by Orhan
|
0 |
603 |
|
|
8KNXP Overclocking by
Bradley Walker
What is the best way to go about overclocking this board? I have a P4 2.8c
and looking to take it possibly upto 3.2ghz. I also have Corsair PC3200 DDR
ram.
Brad
--
___________________________________________________
Get your very own Free and Personal E-mail account for life...
|
|
2 |
603 |
|
|
Slowness and sound problems in many games with GA-7N400Pro2 by
Karl
Hi everyone (and sorry for the long post),
For a short while now, after upgrading my computer (although perhaps
it's more accurate to call it building a new one) I've experienced a
general 'skipping' or 'stuttering' in many games, which is most
noticeable in the sound, although I'm not too sure...
|
April 7th 05 11:17 PM
by smoove
|
3 |
602 |
|
|
8knxp bios 5v fail? by
Dennis
the bios of my rev.1.0 8knxp shows that the 5 volts has failed but the
system seems to be running just fine. i did not oc anything just running
standard it hang when i was using my pinnacle pctv pro for a while, i did a
reboot and all was running fine but stil the bios said that the 5v has
failed,i...
|
October 23rd 03 01:43 PM
by Dennis
|
0 |
601 |
|
|
How find if new motherboard chipset supported in Linux kernel by
James Harris
Can anyone tell me how to check for mainboard Linux support? I cannot
find the two motherboards below (which have eight or more SATA-II
connectors) on any hardware compatibility lists. Any pointers would be
appreciated.
Especially, the Gigabyte mainboard has nVidia 590 chipset. I have an
idea this...
|
|
5 |
601 |
|
|
Which nvidia chipset drivers are newer? by
Wemic
Is it the ver 2.41 drivers on the gigabyte site or the ver 3.13 drivers from
the nvidia site? Can't find the release date for the gigabyte drivers.
TIA
Wemic
|
February 8th 04 04:30 PM
by Wemic
|
4 |
601 |
|
|
|
September 18th 05 11:01 PM
by Slef
|
14 |
600 |
|
|
GA-7N400 Pro2 CMOS to OS hangs on "verifying DMI pool" by
HMGI
Hi all:
How in the world do I get the CMOS to let go ??
Just replaced an old Abit KD7 with a new GA-7N400 Pro2
Had some "wiring" issues but got things running
The CMOS will not release to the Windows 2000 Pro OS on HD 0.
It hangs on "Verifying DMI pool ...
There are 2 HDs, both cable select but...
|
March 13th 05 06:15 PM
by HMGI
|
2 |
600 |
|
|
ITE Raid (Giga Raid) and Windows Update by
NuTCrAcKeR
For those that havent been nailed by this yet, I offer some caution.
I have a 7n400 with the Gigaraid controller. While using the gigabyte
drivers for 2000, I ran windows update. I saw that there was a new drive for
the ITE ... so I downloaded it.
Well ... its the drive for the regular IDE...
|
|
2 |
600 |
|
|
Award Bootblock - Can not find BIOS image in Hard Drive by
Robusie
GIGABYTE GA-8IPE1000-L (rev 2) Socket 478 Motherboard won't post.
My analysis is that the BIOS is corrupt and it is looking for a backup
copy on a hidden partition of the hard drive, (Gigabyte "feature").
Problem is that when this feature activates - board won't look
anywhere else for BIOS.
Can't...
( 1 2)
|
February 19th 07 11:46 PM
by Robusie
|
11 |
600 |
|
|
1Gb DDR sticks with Gigabyte 7N400 Pro2 ?? by
neil smith
Hi there,
Just wondering if anyone could give me a few pointers? I have the 7N400 Pro2
Mobo and currently have 1.5Gb (3 x 512Mb sticks) of DDR. I recently bought a
1Gb stick as I wanted to upgrade to max ram (3Gb) but cant get system to
boot with a 1Gb stick installed.
If the mobo wont take a full...
|
|
3 |
599 |
|
|
There is some driver formga-k8vt800 (2.0) ?. by
Tio
i want create raid 0 with windows xp x64, but my cd installation have not
driver for x64, only 32bits. can help tome?...
byeç1
--
---------------------------------------------------
http://www.gestionagricola.com
http://www.carmelosoft.com
|
January 16th 06 04:33 AM
by jpsga
|
4 |
599 |
|
|
GA-7KNXP: ITE HDD problems, help please by
pagefault
I have a problem doing large amounts of disk I/O from ITE drive to ITE drive
in DOS. By ITE drive I merely mean the Gigaraid ITE controller used in ATA
mode.
WHY in DOS you ask? Well, I use Powerquest Drive Image to create image files
in DOS, and I have found that if both source and target HDDs...
|
August 19th 03 07:59 PM
by Matt
|
5 |
599 |