|
|
NF7-S V2.0 hang problem in windows XP by
Bp_968
After about 2-3 hours of sitting idle, when I return to my system and
attempt to load something new it will "hang" for 1-2 minutes before it
loads the program (IE, explorer, outlook, etc). It will continue to
do this until I reboot the system. It also becomes unstable, so even
if you were patient...
|
|
2 |
358 |
|
|
|
|
0 |
728 |
|
|
NF7-S freezes repeatedly with ANY sound card?!?! HELP!! by
Lauren Royce Emery
I have TWO NF7-S systems and they both hesitate repeatedly when any
sound card is present. No sound card, no hesitation. It hesitates
whether or not I overclock my 2500+. What BIOS settings should I adjust
to stop the freezes?? Thanks!
|
|
0 |
591 |
|
|
Problems installing Zalman 7000A on Abit KD7 by
Bob
I've just installed a Zalman 7000A heatsink/fan to try to quiet down my
system. Unfortunately when I plug everything back in and power up, the
system only gets power for a few seconds then everything turns off. During
those few seconds all the fans spin up, so everything is plugged in
properly, the...
|
October 27th 03 10:14 AM
by Neil
|
2 |
843 |
|
|
Memory limit on VP6 by
Route User
Hello --
Does anyone know why the VP6 is limited to 2GB of RAM, when the Pentium III
can address 4GB?
Thanks,
Route User
--
ABit VP6
|
|
0 |
366 |
|
|
HELP CAN'T BOOT by
lolo
I have upgrade my bios of my nf7s rev 2 with 1.9 but the system can't boot
nothing appear on screen,NOTHING....
I can"'t do anything I AM BLOCKED.....
WHAT SHOULD I DO, PLEASE...........
i read on manual that after i had to clear CCMOS with jumper during few
muinutes but nothing change, no...
|
October 27th 03 03:01 PM
by Skid
|
1 |
337 |
|
|
NF7-S freezes repeatedly with ANY sound card?!?! HELP!! by
Lauren Royce Emery
I have TWO NF7-S systems and they both hesitate repeatedly when any
sound card is present. No sound card, no hesitation. It hesitates
whether or not I overclock my 2500+. What BIOS settings should I adjust
to stop the freezes?? Thanks!
|
October 27th 03 03:15 PM
by Skid
|
1 |
476 |
|
|
NF7-S hangs/hesitates repeatedly with sound activated... by
Lauren Royce Emery
I've got TWO NF7-S systems and they BOTH hesitate for a second or two at
a time at a rate of maybe two or three per minute. Changed power
supplies, memory, even the motherboard to a GigaByte GA-7N400 Pro2 and
the problem persists. What could possibly be wrong? I've tried the
internal sound and...
|
October 27th 03 05:16 PM
by Rob
|
1 |
334 |
|
|
Place to replace bad caps in Europe ? by
Ricardo Ferreira
I have a VP6 with 1 leaking 1500uF 6.3V cap & a bunch of bulging
caps of the same kind. They're all Jackcon.
I'd like to know if someone knows of a company/someone that
replaces caps in the EU. I'm in Portugal.
Its really a shame to throw this board in the trash for a problem
i could probably fix...
|
|
0 |
573 |
|
|
|
October 30th 03 11:11 PM
by kirby
|
0 |
457 |
|
|
Anyone using new Abit AI7? by
dnx
Just ordered this board to use with watercooling.
Same Hardware features as IS7, but has 3.2vdimm and all the new uguru,
blackbox etc. features.
cheers
|
October 31st 03 12:49 AM
by dnx
|
0 |
372 |
|
|
NF7-S by
Gandalf Glimlach
Why ?
Gandalf Glimlach
- be wary of OZC however
Richard Rollins wrote:
|
|
1 |
436 |
|
|
|
|
0 |
578 |
|
|
Adding memory to KX7-333R board by
Eric Robinson
I am currently using a KX7-333R mobo and I have 3 sticks of PC2700 512MB
memory. I have followed the direction for loading the memory into the DIMM
slots (ABIT goes 4 to 1) and everything seemed to work great. then I
started getting a blue screen doing a memory stack dump. I then removed...
|
November 1st 03 11:52 PM
by David
|
1 |
596 |
|
|
Can't change the Barton CPU multiplier on Abit KD7A MB by
AT
I Have a Abit KD7A motherboard with a Barton 2500+ CPU.
All the L3 cpu straps are intact and uncut so the CPU is unlocked.
However I can't change the multiplier. When I use the softmenu and
user configuration it says it changed it but it doesn't. The boot up remains
locked at 11x multiplier. When I...
|
November 3rd 03 10:40 PM
by AT
|
2 |
527 |
|
|
|
November 4th 03 03:00 AM
by kirby
|
0 |
711 |
|
|
|
|
0 |
468 |
|
|
NF7 V2.0 questions by
dgk
I'm considering an ABIT NF7 V2.0, maybe a Barton 2500 or a bit higher.
Mostly I want good performance on disk i/o since I do a lot of work
with large wav files and compression (SHN, FLAC). So I'm thinking of
raid with SATA. But I've heard some bad things about SATA on the NF7.
Not too much here on...
|
|
3 |
534 |
|
|
TH7II with 533 Fsb Processor by
Gé
Hello,
I have:
Abit TH7II with P4 1,6 L2 256kb
Kingston 2 x 128 PC800 RDRAM.
I would like to upgrade the processor.
But the only available P4 processors have a fsb of 533 (4 x 133).
In de bios i can select e.g. for 133 mHz and a multiplyer to 20, so i get
2,66.
|
November 5th 03 11:09 AM
by Yuma
|
1 |
451 |
|
|
IS7-E Problem, Any help? by
David McColgan
I just got this board set up and the guy who set the board up put the HD and
DVD drive on IDE port 2 and the Writer on IDE port 1, i just tried to change
the boot order and the system wouldn't boot at all. It works (only works) if
i have it configured the way the guy set the board up.
Does anyone...
|
|
4 |
447 |