A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
SLI required? by DevilsPGD
I have a GA-K8NXP-SLI and I'm currently using a ATI x550 video card. I don't game, and don't need the SLI capability, but I'm wondering if I can install a second PCI-Ex16 card for use with multi-monitoring or do they have to be configured in SLI and outputting to a single monitor? -- In case of...
October 28th 05 05:37 PM
by ScotsLucky Go to last post
1 342
Small Form Factor Recommendation by Jack
I'm in the market for a SFF PC that has at least two PCI slots and one AGP slot? I would also want it to be a socket 754 motherboard. I want to use this PC for a Windows Media Center 2005 PC. I need two PCI slots because I want to have dual tuner capability and HDTV. I'll probably use an Athlon...
October 27th 05 09:50 PM
by fb Go to last post
8 539
HELP!!! STOP Error 0x0000 0077 by John7
HELP !!! During operation and shutdown a pc has occasionally BSOD's: STOP Error 0x00000077 ( 0xC00000A3, 0xC00000A3, 0x00000000, 0x00C79000 ) MS KB: 0x00000077 and 0xC00000A3 point to "Drive not ready". According to www.dawicontrol.de, DC-133 ATA RAID-controller (w/ Silicon Image SIL-0680)...
October 26th 05 05:00 PM
by Gary Chanson Go to last post
1 508
Another leaking cap problem? by Joe
I have a Gigabyte GA-6VELM Socket 370 motherboard. My computer has started to lock up on me recently. I popped the case, and found 3 capacitors leaking some goo from the top. These 3 capacitors are right next to the processor. When the case is upright, the heat from the CPU rises right up into the...
October 26th 05 01:46 AM
by NewMan Go to last post
2 309
Will Gigabyte GA-7DXE Motherboard accept Leadtek A6600GT TDH AGPx8? by LunaDemo
Dear All, I intended to upgrade my video card from a FX5200 to a Leadtek Winfast A6600GT TDH" 128mb AGP8X. The problem is my GIGABYTE motherboard is very old (Gigabyte GA-7DXE) and it can only support up to AGP4X. (1.5v) Therefore when I went to the shop to buy it, the salesperson advised me to...
October 25th 05 05:41 PM
by LunaDemo Go to last post
0 516
Looking for multi-CPU motherboard by William C
I am looking for a motherboard that will hold 2 or 4, socket 478, P4- 1.5GHz CPUs. 5 PCs at my office were flooded by Katrina. They were a total loss and I have ordered new systems. But looking at the systems, I noticed that although the water came up half way on the MB, the CPU was not wet. ...
October 25th 05 03:35 PM
by William C Go to last post
2 356
Nothing happens after power on by [email protected]
Hi, I have a GA 8IPE1000-G motherboard with a P4 3.0 Ghz installed and 512 MB of DDR memory (one single stick). Yesterday just seconds after a normal Windows start up the pc froze and I had to power it off because no device responded. Then I switched it on but since then I have been unable to use...
October 25th 05 12:51 PM
by [email protected] Go to last post
0 243
Dual Core BIOS Update by Graham
I understand the GA-K8N Pro SLI requires a BIOS update for use with a dual core processor. When starting from scratch can the BIOS be updated with a dual core processor in place? Graham
October 24th 05 06:18 PM
by McGrandpa Go to last post
4 337
GA-K8NXP-9, F8f bios observations by Richard Dower
http://www.gigabyte.com.tw/Motherboard/Support/BIOS/BIOS_GA-K8NXP-9.htm Flashed, bios is dated October 14th 2005. Sadly the NVRAID bios version is still 4.84, even worse is that the bios version for the Sil3114 controller is still 5.1.39, there is a much more recent bios version available...
October 24th 05 02:00 PM
by Richard Dower Go to last post
2 367
GV-NX66T128VP with Vivo by Derek
Would anyone know what chip is used to enable vivo function on this graphic card? The chip itself would be located on the backside. Many graphic card manufacturers used to use Phillips chips but Gigabyte could solder in a chip from any number of suppliers. Also, any comments on using the vivo...
October 23rd 05 07:12 PM
by Derek Go to last post
0 274
GA-K8U-939 running IDE and SATA at same time by [email protected]
I am running my old IDE hard drive with a new SATA drive on the GA-K8U-939 motherboard. For some reason my boot times are taking anywhere from 2 to 3 minutes since I have set ut up this way. Before I hooked up the IDE my boot times were around 20 to 30 seconds. I am running windows XP off of the...
October 22nd 05 07:17 PM
by [email protected] Go to last post
0 343
GA-K8NF-9 internet is not working after updating BIOS by OrionSnake via HWKB.com
Hi there, I have problem connecting to the internet after I update my BIOS from F1 to F7. I tried going from F1 to F6 and it's the same result. Do I need to update the BIOS in sequence? I.e. F1 - F2 - F3... etc. The internet is working fine in version F1. When I did this test, all...
October 22nd 05 03:00 PM
by Nikonja Go to last post
8 564
Im new but require some sound issue help by Teklas
So i have a Gigabyte 8 sigma series mOBO. It has Azalia sound device built in. Well all of a sudden my sound quits working, so I put back in the MOBO cd and reinstall the drivers. Now i have sound but it only allows me sound to my Fronts and Rears and not my center and sub when in the setup...
October 20th 05 08:55 AM
by Mercury Go to last post
1 462
Question on Dual Channel by Chuck Norris
I have two 512 Corsair sticks running in dual channel already. I have another Ultra 512 stick. If I were to buy another Ultra 512 stick exacltly the same, and put that in for Dual Channel Operation also, would there be any problem? I have seen that having the same manufacturer is recomended but...
October 20th 05 04:28 AM
by Mercury Go to last post
1 403
New bios updates by Richard Dower
http://www.gigabyte.com.tw/Motherboard/Support/BIOS/BIOS_List.htm We should see some updates for nForce 4 motherboards soon.
October 19th 05 02:37 PM
by Kilgore Trout Jr Go to last post
3 1,095
Conflict between hard disk and CD-ROM on GA-K8NF-9 by Rob Nicholson
I've just bought some parts to upgrade/rebuild my PC: o GA-K8NF-9 motherboard o AMD 64 3000+ o 2 x 512MB Kingston RAM o G-Force 6000 PCX video card o IBM hard disk configured as master plugged into IDE 0 o NEC DVD writer configured as master plugged into IDE 1 System configured to boot off CD-ROM...
(Multi-page thread 1 2)
October 18th 05 01:13 PM
by Rob Nicholson Go to last post
13 740
Gigabyte accessories? by Richard Dower
http://www.gigabyte.com.tw/MotherBoard/Accessory/AccessoryList.htm#02 Does anyone know how to obtain these items, as i can you purchase them?
October 18th 05 04:30 AM
by Beowulf Go to last post
1 311
October 17th 05 08:32 PM
by [email protected] Go to last post
0 337
GA-K8NF-9, F8 bios by Richard Dower
http://www.gigabyte.com.tw/Motherboard/Support/BIOS/BIOS_List.htm I am hoping this is the first bios update that will cover all nForce4 motherboards. If you have this mobo and flash to F8 can you please report back any differences you notice, date of the bios etc. Importantly can you please...
October 15th 05 12:55 PM
by Rob Nicholson Go to last post
3 331
memtest86 reporting memory error by DevilsPGD
I just purchased a new motherboard, CPU, and video card, built the system, ran memtest86 and I'm getting memory errors. I purchased: Athlon X64 3000+ CPU Gigabyte GA-K8NXP-SLI Radeon X550 P180 Case From my old system I scavenged:
(Multi-page thread 1 2 3)
October 15th 05 08:10 AM
by DevilsPGD Go to last post
23 1,352
Post New Thread


Display Options
Showing threads 1041 to 1060 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 08:41 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.