From when I have installed the version F7 of the bios I have found this problem: when I try to turn on the computer pressing the button of start, it sets out but after 1 according to he extinguishes. If I again press the button of start the computer it doesn't ignite and I am forced to detach the...

I am rebuilding my computer to upgrade from a P4 system. I am re-using the same hard drive and cd-rw drives that I was previously using. All IDE drives functioned properly previous to new MoBo installation. Motherboard, memory and processor are new retail items. I repartitioned my hard drive...

Hi did anyone install this new driver. I had trouble to install the last driver before this one. So I m cautious. Michael

I’m a computer builder, and I’m just trying to finish an upgrade. The new configuration is: MB GIGABYTE GA-8GPNXP 1024 MB TWINMOS DDR 400 VGA ASUS N6200GE 2 IDE/ATA HD 2 IDE/ATA CD-ROM

Hi all, Using the above board I've now got the well-known problem that 2GB in a 4x512 config will only run the Memory @ 166MHz. I've tried A64 Tweaker to run the RAM @ 200MHz but this just locks up the PC. Anyhoo tried to run 200MHz Mem freq. in the BIOS and XP wouldn't load. So I thought I'd...

as the title says, i cant see a option to change my AGP aperture size, all my other gigabyte boards have this option but not this one. i need to change it to see if it helps in stuttering issues playing battlefield 2. GA-K8NS Pro -754 bios F8 xp64-3200 1gig, 6800

!

Hi, Thinking of replacing the stock cooler that came with my A64 3200+ and was wondering if there were any particular issues with the above board. For example would one of the big Zalman coolers fit with the DPS module installed and would I need to un-install the motherboard? TIA BillL

Hi All, I have this very irritating problem with my machine. First off I have got the latest driver for my motherboard which is the Gigabyte 8N-SLI-R. The video card is the GV-3D1 SLI with the latest drivers. Ram 1 Gb DDR2 533 Corsair And that is what my machine consist of oh and a 160Mb SATA...

Hello i have a 7VT600-rz and in the bios and in easytune the temperature is 66° C after 3 minutes and in sisoft sandra and in everest is 38° c do you know what happening, also whatever psu to have the +5v in everest goes from +2.00v till +5.20v in few seconds, is there a problem with my...

I need help with a persistant problem. Recently upgraded from a P4 to an AMD motherboard & CPU. Now I get "Unsafe Removal of Device" pop-ups whenever I dock my iPAQ Pocket PC (and Activesync initiates). Otherwise system is rock solid. Motherboard: GA K8NS Ultra-939 (F6 BIOS) Using lates...

Well i can but fsb goes only to 205 on 210 windows won't start, do i have to put htt on 3 and lower multiplier, because in windows i can do whatever i want from easytune 5 ! I have f4 bios ! cpu is a64 3500 winchester

www.giga-byte.com best regards John

There's an option in bios for robust graphics booster and you can set it to auto, fast or turbo. Did anyone try playing with this, is there any diference ?

Hi, I upgraded a to new Mobo with twin SATA raid hard drives last year. I had a number of problems which I think where down to the SATA chip (most obvious was that often when warm booting it would refuse to recognise the SATA drives). Anyway, last week the boot partition became corrupted so I...

Hi, I have a K8NXP-9 board and 2 x Corsair CMX1024-3200C2 RAM. The RAM is rated at 2.5-3-3-6 timings, but the BIOS on the motherboard (F6) sets it at 3.3.3.8 by default. I can change the timings in the advanced chipset setup menu in BIOS. However, the BIOS ignores the last three timings,...

Hello, I'm using a Gigabyte GA-8I945P Pro motherboard. It has latest Bios (F5) I've connected 4 IDE hard disk on the ITE8212F controller of the motherboard : Primary IDE master: first IBM 60 GB hard disk Primary IDE slave: Western Digital 120 GB Secondary IDE master: second IBM 60 GB hard...

I just built a system around the k8nxp-sli and it has built in ALC850 sound. Everything "works" but the sound definitely sounds "tinny" like a cheap radio. I'm using the same harmon kardon speakers from my 5 year old Dell that also used onboard audio and there is definitely a sound quality...

I check the website, the different of the 2 board seem only the IEE1394 and dual BIOS. Question, If I get a 945P-G. Can I add Dual BIOS by just adding a additional EEPROM chip ?

Hello, I've installed a GA-8I945P Pro and a Pentium D 830. The Intel fan make a lot of noise I think about a Zalman CNPS7700 fan unfortunatelly, the CNPS7700 Compatible Socket 775 Motherboard List contain only older motherboard http://www.zalman.co.kr/product/cooler/7700-775MBlist_eng.htm