A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
[GA-EP35C-DS3R] Plextools can't use a Plextor writer connected tothe Gigabytre SATA ports by Hueyduck[_2_]
Hello eveyone, I connected a Plextor PX-801SA drive to one of the 2 Gigabyte SATA ports (the urple ones, not the orange ones). Everything worked fine as far as reading was concerned. Yesterday, I installed plextools, wich I find sufficient for my writing needs. Plextools sees the drive but acts...
December 30th 08 07:53 PM
by Kris[_2_] Go to last post
4 658
Odd POST sequence by Stephen Russell
Found out something with the new X58 boards. With the dual BIOS you may get an odd POST sequence. I just built a new system that worked fine for two weeks. Yesterday it started an odd behavior. When I press the case power button, the fan LEDs and fans come on for a half second or so, and...
December 28th 08 06:42 AM
by Kris[_2_] Go to last post
1 433
Overheating Issue by Dave[_36_]
I upgraded my computer recently to a new motherboard/cpu/etc.. and I'm having a lot of overheating issues with it when I do intense 3D renders. At present I have the following: GIGABYTE GA-MA78G-DS3H AM2+/AM2 AMD 780G HDMI ATX AMD Motherboard AMD Athlon 64 X2 4800+ Brisbane 2.5GHz 2 x 512KB L2...
December 28th 08 06:36 AM
by Kris[_2_] Go to last post
6 811
System Thermal Sensor Location? by Scrim
I have a new GA-EP45T-DS3R (rev. 1.0) and I can't locate the motherboard/system thermal sensor. The Motherboard/System thermal sensor shows an idle reading of 42C with the case sides off, higher than any of the other sensors. If I stress test the PC this actually drops to 35C, presumably because...
December 14th 08 07:49 PM
by Scrim Go to last post
0 394
header 4 by Reijo Vainio
BANG! Maailmankaikkeuden historia./Neutriino. Neutriinot ovat pieniä ja hyvin kevyitä hiukkasia. Niitä syntyy ydinfuusiossa, jotka toimivat tähtien (esimerkiksi Auringon, perusydinvoimalan) energian lähteinä. Useiden vuosien ajan neutriinojen oletettiin olevan massattomia, mutta nykyään tiedetään...
December 9th 08 04:07 AM
by Reijo Vainio Go to last post
0 1,046
Bad AGP? by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
December 8th 08 02:15 AM
by Rudy Go to last post
4 441
GA-EP5-UD3P 5 sec beep on cold powerup. Why? by Kris[_2_]
Wondering what's up with the 5 sec beep on cold powerup (pressing the power button on front)... tia!!! Great board!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! -- Kris ---------- Gigabyte GA-EP45-UD3P | E7200 | Vista on 36GB Raptor |
December 4th 08 06:32 AM
by Kris[_2_] Go to last post
3 828
AGP by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
December 4th 08 01:20 AM
by jpsga Go to last post
1 314
AGP? by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
December 2nd 08 03:41 AM
by Paul Go to last post
2 349
AGP by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
November 30th 08 05:14 AM
by Rudy Go to last post
0 336
AGP by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
November 30th 08 05:13 AM
by Rudy Go to last post
0 286
AGP by Rudy
I'm using a GA-7N400 Pro2 mobo with a quadroFX 3000 video card. I have had a few incidents where the picture went all crazy and thought it was the card going. Today I plugged my USB flash drive in and the computer froze. Had to soft off. Now when I try to boot there is no video signal at all. No...
November 30th 08 05:13 AM
by Rudy Go to last post
0 321
Is higher DDR speed than FSB speed ok? by Don[_15_]
My motherboard has a 533 mhz fsb bus and the recommended DDR speed is 333 MHz (PC2700). Will I lose on performance or damage anything if I use a DDR 400 MHz (PC3200)?
November 27th 08 06:25 AM
by geoff Go to last post
4 365
G31M-S2L by Caulfield_man
Hi folks Been running this MB (G31M-S2L) for a few weeks now; rock solid and working a treat. Yet have this nagging fear I should have bought a better MB... Any thoughts?
November 25th 08 11:41 PM
by Caulfield_man Go to last post
2 791
Lost left sound on my Gigabyte P35-DS3L rear panel sound out by Keith
Lost left sound on my Gigabyte P35-DS3L rear speaker output. The front panel connector works correctly. How do I troubleshoot to dtermine if the cause is hardware vs software?
November 24th 08 07:19 AM
by Kris[_2_] Go to last post
6 650
GA-MA78GM-S2H Equivalent with ECC by geoff
Hello, I like this board but is there an equivalent one that has ECC also? Thanks. --g
November 23rd 08 08:09 PM
by geoff Go to last post
3 450
GA-EP45-UD3 Verifying DMI Pool Data stops sometimes by Herbert Meister
I unpluged it but it did not help...
November 21st 08 04:51 PM
by Kris[_2_] Go to last post
1 735
Disneyn Pieni merenneito -leffan ravun koko nimi by Kalle Heiskanen
MTV 3. 07.06.2008. "Norjassa tuulivoima myötätuulessa. Norjan energiatarpeista PUOLET voidaan kattaa tuulivoimalla, kun nykysuunnitelmat toteutetaan! Kaiken kaikkiaan 130 tuulivoimalapuistohanketta on haettu rakennuslupaa Norjan energiavirastolta. Jos kaikille halukkaille myönnetään lupa...
November 21st 08 12:24 PM
by Kalle Heiskanen Go to last post
0 596
What does the "performance enhance" setting actually change ? by Hueyduck
Hi everyone, As I am struggling to make my memory work in a stable way, I find that ther is something I don't understand in the BIOS of my GA-EP35C-DS3R. Just above the memory speed setting, there is a "performance enhanced" wich is , by default, turned to "turbo". Choices a Standard
November 18th 08 08:21 PM
by timelord Go to last post
6 316
GA EP45-DS3P by Beemer
What is the correct procedure to use the illuminated cmos reset button on my GA EP45-DS3P? There is nothing in the manual/ regards, Beemer
(Multi-page thread 1 2)
November 14th 08 04:48 AM
by Onsokumaru Go to last post
16 1,165
Post New Thread


Display Options
Showing threads 221 to 240 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:47 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.