|
|
8IHXP STR issue with f8 bios by
~Von
Answering my own question and posting FWIW under a more relevant subject.
It turns out my trouble getting my 8IHXP out of STR was in fact related to
the f8 bios. When I reverted back to f7, STR now works perfectly. This is
one of those cases where I should have just left the bios alone as I am...
|
|
1 |
363 |
|
|
GA-8IHXP: f8 boot conflict w/ Promise Raid0 and adaptec 29160 scsi card by
~Von
I'm hoping someone can assist with a booting issue that I have with my IHXP.
I am currently running XP Pro off of a raid 0 array on the on-board promise
controller. It works fine. I also have an Adaptec 29160 with a scsi drive
attached with an install of win98 and MDK9.1. WHen I boot to XP, it...
|
|
1 |
1,028 |
|
|
POST problem Gigabyte GA-P55A-UD3 rev.1 by
~PCfreak ©~
hello
I build á system with the following spec's for my brother;
Gigabyte GA-P55A-UD3 rev.1
Core i7 870
4x2 GB Kingston hyperX kit
W7 64 bit
In the beginning the system was booting perfectly, also the POST went
|
|
0 |
1,046 |
|
|
GA-MA780G-UD3H by
~PCfreak ©~
hello
I have a GA-MA780G-UD3H motherboard and works fine, but the coolingblock
on the AMD-780G chip gets very hot. Is this normal because I am a bit
worried about it.
groetjes Henk
--
#Een reactie van de vraagsteller of een gegeven oplossing
gewerkt heeft wordt zeer op prijs gesteld#
|
|
0 |
1,096 |
|
|
|
September 16th 08 08:28 AM
by jk
|
6 |
610 |
|
|
xp and 98 installation problem (disperate) by
_iNsAnE_
Hi,
I'm disperate, I've (for a firend of mine) make a pc with this components:
Case Middle tower 400w power
Cpu intel P4 2600 478pin 800MHz
HD: Maxtor Serial ATA 80 GByte
Ram: 1 DDR400 Kingstone 512 MByte PC3200
MotherBoard: Gigabyte GA-8IPE1000
Display Adapter: ATI Radeon 64 Mb (I think AGP...
|
|
5 |
176 |
|
|
GA-8IPE775 Pro and no hard drive activity signal by
_
Hi All,
I've got a new motherboard of the one mentioned in the topic. The HDD
activity LED doesn't work. I made sure the LED itself want's faulty by
plugging it into the power indicator connector, and it does turn on.
I've checked/swapped/tried opposite polarity, and still no go.
Any ideas?
|
February 17th 05 08:47 AM
by _
|
0 |
313 |
|
|
GA-8VM800PMD-775-RH 1gb + 512mb = 1gb ???? by
\A_Michigan_User\
GA-8VM800PMD-775-RH
I'm trying to mix a 1gb stick, with a 512mb stick. But I only get a total
of 1gb, instead of 1.5gb, as expected.
Can't find anything about "all sticks must be the same size" on the Gigabyte...
( 1 2)
|
June 14th 09 09:08 PM
by andy
|
19 |
1,489 |
|
|
[ GA 7N400 PRO2 rev.2.0 + Adaptec 39160 ] by
[ DreamK ]
Hi ;)
I would like to know if someone managed to install this main bord (under
bios v.FJ) with this scsi extension card.
====================
PROBLEM :
====================
the scsi bios message is not shown at the boot
CTRL-A is not working
( 1 2)
|
|
10 |
3,455 |
|
|
GA-7N400 Pro2 + Athlon XP-M 2500+ can overclock well ? by
zork
Hi,
Does anyone know much about XP 2500+ Mobil cpu's and if they do well in the
GA-7N400 pro2 board? Can they be successfully overclocked? And what RAM
should I get? I have the inclination to go towards 2 x 512 MB A-DATA ram. Is
this good ram from a good company? I did hear that it is good...
|
|
3 |
276 |
|
|
GA-7N400 Pro2 ? Good board ? And what is Rev 2.0 ? by
zork
Hi, I am interested in getting a new system together. I am strapped for
budget. So I dont want to get in on the 64ish stuff.
I am considering:
1 Gigabyte 7N400Pro2 Motherboard
1 AMD AthlonT XP 2800+ Processor Retail (Barton Core)
512M PC3200 DDR RAM Kingmax
Can anyone advise whther this is a...
( 1 2)
|
|
11 |
260 |
|
|
GA-7VRXP + AMD 2000+ = 1250MHz ??? by
zork
Hi I have a GA-7VRXP and an AMD 2000+ cpu. I am getting 1250MHz on my
poweron screen. I thought the AMD 2000+ would give me atleast 1.67 GHz. I
went into bios and loaded up all defualt settings. I have set the jumpers on
the mainboard as default jumper settings. With everything in default mode,...
|
August 1st 04 05:50 AM
by zork
|
2 |
113 |
|
|
GA7N400 Pro Slow IDE Raid by
Zoney
Hi all,
I recently purchased the above mobo and set up a Raid 0 (Stripe) using
2 ATA 133 60gb drives.
Using Sisoft benchmark the speed of this drive is returning 27,000,
which is well below what it should be (probably close to double)
I previoulsy had these drives on an ABIT mobo using raid and...
|
|
4 |
456 |
|
|
GA-7N400 Pro by
Zoney
Hi everyone,
Any thoughts on this board?
Is it new? I haven't seem much around in ways of reviews for it and am
probably going to pick one up later.
Any opinions appreciated.
Thanks.
|
September 4th 03 01:59 PM
by jpsga
|
1 |
331 |
|
|
Black screen after bios update by
Zond
I've updated my Gigabyte K8NS bios from F6 to F17. The update seems to
have terminated successfully (message appear).
Unfortunately I'm not able to boot my PC.
During the boot process screen remains black and the motherboard repeats
a long beep. I've tried to reset cmos first with the jumper and...
|
|
2 |
462 |
|
|
GA-7NNXP no VRM Card by
Zogg
Hi,
I've just bought one of these boards as 'refurbished' at a very good
price but it's missing everything except the board itself. I've got
cables etc. and can download manuals, drivers etc from the Gigabyte
website. The main thing that concerns me is the missing VRM card. Will
this board work...
|
|
2 |
108 |
|
|
GA-8KNXP Ite 8212 controller by
zm
Anyone have problems keeping Java runtime environment(all versions)
running on the 8knxp ver. 2.0( not ultra) when using the Ite 8212 as an
ultra 133 setup, not raid. I have the operating system installed on
drive C: on IDE3 and drive D: on IDE4, both masters. I have also CD-RW
as master on IDE1...
|
|
2 |
268 |
|
|
GA-8INXP - SATA-Raid while PATA is present by
Zippo
Hello!
My Problem! I Installed a Raid Array on the onboard sata controller!
For this i used 2 160GB Samsung drives! I created the array in the
controller bios and installed the drivers in my on a PATA installed
Win XP! Now I could use the Raid Array
(formating/partitioning/Writing/reading)!
The...
|
January 26th 04 02:26 PM
by Zippo
|
0 |
402 |
|
|
GA-8INXP - SATA-Raid while PATA is present by
Zippo
Hello!
My Problem!! I Installed a Raid Array on the onboard sata controller!
For this i used 2 160GB Samsung drives! I created the array in the
controllerbios and installed the drivers in my on a PATA installed Win
XP! Now I could use the Raid Array
(formating/partitioning/Writing/reading)!
The...
|
January 26th 04 04:34 PM
by Zippo
|
0 |
448 |
|
|
Award/Gigabyte beep code Mystery by
[email protected]
I think that this is a new one. Continuous long beeps, presumably
dram errors, but ONLY when the computer boots up in XP safe mode.
Any ideas?
SYSTEM:
DualCore AMD Athlon 64 X2, 2000 MHz (10 x 200) 3800+
Motherboard Name Gigabyte GA-M61PM-S2 (2 PCI, 1 PCI-E x1, 1 PCI-E
x16, 4 DDR2 DIMM,...
|
September 20th 08 05:12 AM
by Paul
|
1 |
483 |