Guys can someone advise...? My hardware is not up to it I believe.... I have a A2500, 512m DDR, with a GForce 4800Ti SE 128m video card.... Doom 3 used to crash all the time midgame.... however HL2 is now doing it to me, however this time it returns the following error message.....

Windows failed to load after installing two one gig DDR2 sticks on my laptop. Ran memtest86 v3.2 and each stick passed when it was the only one installed (either slot). Got errors when both were installed at the same time. Tested with one new stick and the original 512 meg stick with no errors...

Hi. I just purchased 512MB of new memory today - OCZ DUAL DDR PC-3200 Performance Series Rev. 3 Dual Channel, 512MB, PC400. I installed it on my Dell Dimension 4600 (which already had 512M of RAM Dual Channel). Here is the report on my computer BEFORE installing the...

Hi Purchased new Kingston Value Ram PC2700 1Gb chip, this works fine on its own no problems at all. And my old memory Samsun PC2700 two lumps 512 and 256, they also work fine no problems. However when used together in any combination the system will only see the old chips, i have played with the...

Hi Purchased new Kingston Value Ram PC2700 1Gb chip, this works fine on its own no problems at all. And my old memory Samsun PC2700 two lumps 512 and 256, they also work fine no problems. However when used together in any combination the system will only see the old chips, i have played with the...

I just got another 512M DDR chip, but every time I install it my video drivers go ?? its a wierd problem, I have installed lots of memory in the past, and it just updates. but this time I install it, and I can't play any of my games?? when I reinstall newest video drivers it crashes, but then when...

Hi everyone, I have a 6835 Hp pavilion , that has only 2 memory slots , originally there was 2 pc100 , 64mb sticks of ram, I have done research and found the crucial.com is good for determining what memory is compatible with my pc , according to crucial, it says it will accept pc133 ram alright ,...

If I was to get a m'board capable of running DDR memory in dual mode what would general perfomance difference be between running: 2 X 512 PC2700 2 X 512 PC3200 or in non-dual mode 1 X 512 PC3200

Hi, I have just set up an elderly PC with a MyComp VP3-586B-W877 motherboard running an AMD K2 450mhz. Old, I know, but it does all that is required. The PC originally had one 128mb SDRAM module which was in the first of three banks and was recognised and worked fine. I added a second 128mb...

Hi, I have a new quadcore Acer Aspire E 15 that has upgraded itself to Win10. I purchased it with 4 GB RAM installed. MS Task Manager says of the Memory, Speed: 1333 MHz, Slots used: 1 of 2, Form factor: SODIMM, Hardware reserved: 117 MB. I presume 117 MB is reserved for video. Unfortunately,...

Simple question (I hope). My Mb supports both 400MHz-PC3200 and 333MHz-PC2700 memory. I currently have 2 256 333MHz-PC2700 Dimms in place on the mb, and I want to add a 512 in an empty socket for 1G total. My question is should I buy PC2700 to be compatible with the memory already in place,...

I need to buy a replacement 512 MB memory module, which on the suppliers website are marked "for PC2100, PC2700, PC3200". What is the significance of these numbers?

Hello, I have a Biostar Motherboard (M7NCD). I am trying to figure what type of memory I have installed. When my computer boots it says memory 266. If I run Aida32, and run a bench mark test it groups my memory with the PC2100 type memory. Belarc Advisor does not give accurate information either....

have a Dell that takes PC133 RAM. If I put PC2100 RAM in there, is it backwards compatible? Will it run at 133?

Hi, I have a computer with an Asus A7N8X Deluxe rev 1.04 mainboard. It currently has one double-sided 512MB PC2700 DDR DIMM and an Athlon XP2600+ processor. The FSB and memory both run at 333MHz. Since this computer often running quite a lot of software (simultaneously) I would like to increase...

I am upgrading the memory in a four year old Dell Dimension 4100. I want to purchase two 256MB modules. The memory requirements a non-ECC PC133 SDRAM freq - 133MHz non parity Unbuffered Not all the memory I see listed states if it is ECC or non-EEC. Can I tell by the configuration (32 x 64)...

I currently have (2) sticks of 256 MB DDR PC 2100 266MHz in my system. I want to add more memory and want to find out if I add (2) 512MB PC2700 DDR DIMM Memory will they work together ok? The two 256 sticks are currently set up in Dual Channel mode.

I am running Windows XP and up until recently had two sticks of SDRAM Memory in my computer 1x 128MB and 1x 256MB. I upgraded by removing the 128 stick and replacing it with a 512MB stick. I notice no difference in performance. I told an associate about this and they suggested that the LARGER of...

I have put a new memory stick into my XP x64. I removed two 512 MB sticks. This new one is 1024 MB. Why would my system still be saying I have 896 MB of ram? Do I need to do something in BIOS? When I had a 1024 and a 512 MB in there it was showing I had 1.3 GB of ram. How much Ram can XP...

Dumb question... I have an HP a1310n desktop with 4 memory slots - all white. I'm new to 'dual channel' in terms of memory... it was on the memory stick I just bought... What does this mean in terms of my motherboard? According to the HP web site, the motherboard is an ASUS model A8AE-LE. ...