A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : General Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
XP failing to install by [email protected]
This really is about hardware. 6 months ago my son in London tried to re-install XP. He couldn't get the HD to format. The system hung part way through. Assuming it to be the HD he bought a new 160Gb HD but got the same result. The next thing was to check the memory by taking out one of the two...
(Multi-page thread 1 2)
December 20th 05 07:31 PM
by Go to last post
17 666
usb hard drive by udayajivi
Hello, I going to buy a usb hard drive (250gb) , but i don't know if conceptronic is better lacie. Can somebody help me? Thanks
December 20th 05 06:00 PM
by udayajivi Go to last post
0 196
AGP backwards compatible? by Sparky
I have an older MB with a first generation AGP slot. I want to replace the old card with a relatively newer video card. Can I use an 2x AGP or x4 card? Are they backwards compatible? Any help appreciated.
December 20th 05 05:21 PM
by kony Go to last post
4 400
Graphics Card - Which One - Help by Craig1983
Got a refund today on my faulty graphics card, and now looking at getting a new one. Faulty card was a Geforce 6800 GT 256MB Ram I haven't been keeping up much with the latest developments since buying this so am a bit out of touch. I got a budget of around £200 and am a bit confused over...
December 20th 05 01:29 PM
by GT Go to last post
2 247
PSU by Dave Zass
I just replaced a 465w PSU with a 520w PSU. However, the grid on the side of the PSU would lead me to believe that I just "downgraded" the PSU. The original, a 465W Enermax, shows the following: +3.3V 36A +5V 44A +12V 20A -5V 2A -12V 1A
December 20th 05 07:44 AM
by kony Go to last post
8 502
Only person in complex with internet; should I worry about hackers? by Go Tyler
I have been setting up my wireless network and making sure the router works and has at least wpa set. I changed my attenae strength to 50% on my router because 2.4ghz linksys usb adapter picks the signal up fine at 50%. However, I know for a fact that within 500 feet of me there is not one person...
December 20th 05 07:08 AM
by Ian East Go to last post
4 601
Asus A7v333 AGP Pro 4x slot Radeon 8500 died. Which card? Radeon 9550? or Geforce 6600 or X? compatible by Darren
Hi ***My system is an Asus A7V333 mobo (4x AGP PRO 1.5volt), Athlon 2200 and is in need of a new video card.*** I had a Radeon 8500 pro, which for my gaming and spreadsheet needs was fine. I do have a heat issue with my case and so I added a large heatsink with fan to the video card, to fix the...
December 20th 05 06:23 AM
by Darren Go to last post
4 1,041
how do u test mo board/mem/modem??? by [email protected]
I had a power supply problem, bought another and now having problems, had the p supply checked,,, is ok. But now the computer will 'freeze' and has to be powered off, (control alt del) will not work. But while the machine is working,,,, it seems slower than before ''powersupply problem/replace"...
December 20th 05 04:00 AM
by Paul Go to last post
1 332
Power Supply by Dave Zass
I just replaced a 465w PSU with a 520w PSU. However, the grid on the side of the PSU would lead me to believe that I just "downgraded" the PSU. The original, a 465W Enermax, shows the following: +3.3V 36A +5V 44A +12V 20A -5V 2A -12V 1A
December 20th 05 02:11 AM
by kony Go to last post
5 233
Exabyte TR-3 and XP? by Chris_Signe
Can an Exabyte Eagle TR-3 tape backup drive work with Windows XP? Thanks. Chris
December 19th 05 07:26 PM
by Chris_Signe Go to last post
2 282
Interrupt Handling by Henning Sudbrock
Hi, as far as I know there's the possiblity that certain Interrupt Requests (IRQs) can be masked, either by hardware or by software. Assume that some device requests an interrupt while the corresponding Interrupt Line is masked. What happens then? Is the Interrupt Request put into some sort of...
December 19th 05 04:54 PM
by Bob Go to last post
1 442
Connect printer to wireless network? by itemyar
I have two computers on a wireless network; my main computer is hard-wired to a Wireless DSL router, but I do most of my computing in the kitchen with my second PC, a long way from my main computer's location. I have a Brother laser-printer connected to my main computer via the parallel...
December 19th 05 04:36 PM
by Toxic Boy Go to last post
5 513
insulating sheet for hard drive PCB by [email protected]
Hi, I just had to buy a replacement for my dead laptop hard drive (Hitachi Travelstar in an Armada E500). The original drive has its printed circuit board insulated with an adhesive sheet of silver-colored plastic. Does anybody know a company that makes this kind of insulating sheet, or, even...
(Multi-page thread 1 2)
December 19th 05 02:00 PM
by Terry Turnip Go to last post
17 632
code 12 by [email protected]
hi, i have a msik8n neo 754 mobo amd64 and a 6800gt agp installed. i have just aquired another graphics card nvs400 quadro pci card. my problem is when i put the quadro card in windows picks it up fine and then i get a code 12 on the 6800gt card. i have booted into safe mode and it is a memory...
December 19th 05 01:53 PM
by [email protected] Go to last post
0 334
Measuring Signal Strength with tuner and software? by Jack
Hi. Is it possible to measure an incoming video signal strength with just an onboard tv tuner (with a connected cable system connection) and associated software? Thanks. Jack
December 19th 05 01:16 PM
by Gerard Bok Go to last post
1 321
Need help with Onspec hard drive enclosure CT-9202A by geezer
I have an Onspec hard drive enclosure CT-9202A REV 2 3 that I used to use with W98SE satisfactorily. I put it aside a while ago, but now I want to use it with my WXP PRO. I can't get it to work! When I try 'add new hardware', the drivers seem unacceptable to WXP. I downloaded the W2000 set of...
December 19th 05 10:44 AM
by geezer Go to last post
2 384
Mouse not working on KVM switch by Conrad
I've just bought a new Belkin 2 port KVM switch so that I can use a monitor, and a PS2 keyboard and mouse with 2 Winodws XP desktop computers. The mouse refuses to work on my old computer but works fine on my brand new computer. I did the obvious checks like checking that everything was plugged...
December 19th 05 10:09 AM
by philo Go to last post
4 594
does a wireless mouse affect audio and wireless connections? by Toxic Boy
What effect does a wireless mouse have on computer audio and wireless connections?
December 19th 05 02:58 AM
by kony Go to last post
3 1,397
AMD 64 or Pentium 4? Which one for new mobo? by Go Tyler
I am getting a new mobo soon in the 995 socket. I have always used Pentium 4, so I know what to expect from it. But what about Athlon 64. Which would you go with, and why?
(Multi-page thread 1 2)
December 19th 05 01:04 AM
by Jamie Go to last post
11 433
Will Ghost read from a USB external drive? by Dave
I'm going to replace the C drive in one of my computers and want to create its image on an external USB drive to be written to the new drive. When I boot the comp from the Ghost CD, will it be able to "see" the USB drive?
(Multi-page thread 1 2)
December 19th 05 12:10 AM
by kony Go to last post
12 495
Post New Thread


Display Options
Showing threads 9201 to 9220 of 20259
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 08:36 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.